Home > Home & Marine Upgrades > Blower Motors >

Packard 66757 Replacement Carrier Draft Inducer Blower Motor 115V 3000 RPM 58W PSC

Packard 66757 replacement Carrier draft inducer blower motor 115V 3000 RPM 58W PSC with 3-prong Molex plug and capacitor
Packard Replacement Carrier Draft Inducer Blower Motor, 115V, 3000 RPM
 
List Price: $299.99
: $214.49
You save $85.50!
Part Number: 66757
Manufacturer: Packard

Quantity in Stock :35

Free Shipping
Availability: In Stock
Qty:

 
Packard 115V / 3000 RPM Replaces Carrier 320725757 Packard 66757 Replacement Carrier Draft Inducer Blower Motor

The Packard 66757 is a direct replacement draft inducer blower motor engineered to restore proper combustion venting in Carrier furnaces. This 58-watt PSC motor runs at 3000 RPM on 115V/60Hz power, features ball bearing construction for long service life, and ships with the capacitor already included -- so you have everything needed to complete the swap without hunting down additional parts.

Direct-Fit Carrier Inducer Motor Replacement

Draft inducer motors draw combustion gases through the heat exchanger and exhaust them safely out of the flue before and during burner operation. When the original motor fails -- common symptoms include furnace lockout, pressure switch faults, or audible bearing noise -- the Packard 66757 restores full inducer function with a plug-and-play fit for the listed Carrier applications.

This motor uses the same 3-prong Molex connector as the OEM unit, simplifying the electrical connection. Automatic thermal overload protection guards against motor burnout if airflow is restricted or the unit is run outside normal operating conditions.

Capacitor Included

Ships with the run capacitor pre-matched to the motor -- no separate sourcing required for a complete installation.

Ball Bearing Construction

Ball bearings deliver longer service life and quieter operation compared to sleeve-bearing alternatives.

3-Prong Molex Plug

Matches the OEM wiring harness connector on compatible Carrier models for a straightforward, no-splice installation.

Thermal Overload Protection

Automatic overload protection shuts the motor down if it overheats, protecting the motor and furnace control board.

Compatible Replacement Applications

The Packard 66757 directly replaces the following OEM and aftermarket part numbers:

  • Carrier 320725757 -- OEM draft inducer motor
  • AllTemp FB-RFB757 -- aftermarket equivalent
  • Rotom FB-RFB757 -- aftermarket equivalent

Also sold and referenced as NBK Parts 20289. Verify your existing motor's part number against this list before ordering to confirm fitment.

Complete Kit: Unlike some aftermarket motors sold without supporting components, the Packard 66757 includes the matched run capacitor. This eliminates a common installation headache and ensures the motor operates within its designed electrical parameters from day one.

Motor Type and Performance

This is a PSC (Permanent Split Capacitor) motor, the standard type used in residential and light-commercial furnace draft inducers. PSC motors are efficient, reliable under continuous-duty cycling, and well-suited to the variable-load demands of an inducer application. Single-speed operation matches the OEM configuration on compatible Carrier units.

Class B Insulation: The motor windings are built to Class B insulation standards, rated for continuous operation up to 130 deg C (266 deg F) winding temperature -- appropriate for the elevated temperatures found in furnace flue environments.

Installation Notes

  • Confirm furnace power is fully disconnected at the breaker before beginning any motor replacement work.
  • The 3-inch diameter inlet mates directly to the standard inducer housing flange on compatible Carrier units.
  • Reconnect the Molex plug, attach the flue outlet tubing, and confirm pressure switch hose routing before restoring power.
  • After installation, verify the furnace completes a full ignition cycle and that the pressure switch closes properly.
Maintenance Tip: While the inducer housing is removed, inspect the flue outlet tubing and pressure switch hose for cracks, blockages, or condensate buildup. A clogged or cracked hose is a frequent cause of repeated pressure switch faults even after a motor replacement.

Electrical Specifications

Voltage115V AC
Frequency60 Hz
Amperage1.16A
Wattage58W
Motor TypePSC (Permanent Split Capacitor)
SpeedSingle speed
RPM3000 RPM
Insulation ClassClass B

Physical Specifications

Inlet Diameter3 inches
Bearing TypeBall bearing
Connector3-prong Molex plug
Motor Weight6 lbs

Protection and Rating

Overload ProtectionAutomatic thermal overload
Insulation RatingClass B (130 deg C / 266 deg F)

Part Number Cross-Reference

Packard Part Number66757
NBK / Vendor Part20289
Replaces Carrier OEM320725757
Replaces AllTempFB-RFB757
Replaces RotomFB-RFB757

What Is Included

Draft Inducer MotorYes -- Packard 66757
Run CapacitorIncluded
Molex Connector3-prong, pre-installed
Important Information
  • Disconnect all power to the furnace at the breaker before removing or installing this motor. Draft inducer motors operate on 115V AC -- failure to de-energize the system creates a serious shock hazard.
  • Verify your existing motor's part number (Carrier 320725757, AllTemp FB-RFB757, or Rotom FB-RFB757) before ordering. This motor is not a universal inducer replacement and may not fit other Carrier or non-Carrier models.
  • Do not run the motor outside the housing or without proper flue connection. Unvented combustion gases are a carbon monoxide hazard.
  • This motor is rated for 115V / 60Hz systems only. It is not compatible with 230V or 50Hz electrical systems.
  • After installation, confirm the furnace completes a successful ignition cycle and that no fault codes are stored on the control board before returning the furnace to service.


Browse for more RV Accessories in the same category as this item:

Home & Marine Upgrades > Blower Motors
Home & Marine Upgrades


$151.00
$568.99