Purpose-built for pickup truck campers stored off the truck, the Classic Accessories PolyPRO3 Model 2 cover wraps your unit in three-ply weather protection while staying easy to install solo. Adjustable tension panels, an integrated rope system, and zippered access doors make this a practical long-term storage solution for 10- to 12-foot cabover campers.
Truck campers are a substantial investment, and leaving one uncovered during off-season storage invites UV damage, moisture intrusion, dirt buildup, and wind abrasion. The Classic Accessories PolyPRO3 Model 2 is engineered specifically for this use case -- it is designed only for campers stored on the ground, off the truck, and it shows in every design detail.
The PolyPRO3 fabric system uses a three-ply construction: a durable outer layer that sheds rain and blocks UV, a middle layer for breathability and shape retention, and a soft inner layer that will not scratch painted or gel-coat surfaces. The sides incorporate quick-drying PolyPRO material that lets air circulate while limiting wind load on the cover.
Air vents combined with breathable PolyPRO side panels reduce wind stress and allow interior moisture to escape, preventing mildew buildup during long storage periods.
Strategically placed zippered panels let you reach camper doors, exterior compartments, and utility hookups without removing the entire cover.
Front and rear tension panels combine with elasticized hem corners to pull the cover snug against the camper's profile, minimizing flapping and reducing abrasion.
An integrated rope attachment system and an included toss bag help you run tie-down straps under the camper without crawling on the ground.
The "3" in PolyPRO3 refers to the three-ply laminate that sets this fabric apart from single-layer polypropylene covers. The outer face sheds precipitation and resists UV degradation. The middle membrane adds dimensional stability so the cover holds its shape in wind. The inner fleece-like layer provides a buffer between the fabric and your camper's exterior surfaces -- protecting decals, paint, and sealant from contact abrasion.
This cover is built for campers sitting on their jacks or a storage stand -- not for use while the camper is mounted on a truck and being driven or towed. The hemline, tie-down geometry, and tension-panel placement are all calibrated for a stationary, ground-level unit. Using it while driving will void the warranty and risks damaging both the cover and the camper.