Purpose-built for truck campers in the 6-to-8-foot range, this cover combines a thick triple-ply PolyPro3 top with single-ply PolyPro1 sides to block rain, snow, UV rays, dirt, and road grime all year long. Zippered access panels, an integrated air vent system, and an elasticized hem mean you can cover the rig quickly and still reach the door without pulling the whole cover off.
Truck campers face a unique storage challenge: they sit exposed on the bed, catching weather from every direction, including road splash underneath. Classic Accessories designed the PolyPro3 line specifically for this application. The layered construction starts with a triple-ply PolyPro3 top panel that sheds standing water and resists UV degradation, while the single-ply PolyPro1 sides allow moisture vapor to escape so condensation does not build up inside against your walls and roof.
The 01-0918 cover fits camper trucks up to 8 feet long and 8 feet wide, covering the most common short-bed and standard truck camper configurations. At 13.2 lbs, it is manageable for one person to deploy, and the included toss bag and integrated rope attachment system eliminate the need to crawl under the truck to feed straps through.
The PolyPro3 top layer is thick enough to resist punctures from branches and debris while still repelling water and blocking UV rays that fade and crack your camper's exterior finish.
Passive vents combined with quick-drying PolyPro1 side panels reduce wind billowing and expel trapped moisture, preventing the mildew and corrosion that can develop under an unvented cover.
Front and side zippered panels provide access to the camper door and cab-over entry without removing the cover -- essential for grabbing gear during off-season storage or checking on the interior.
Adjustable front and rear tension panels combined with elasticized hem corners pull the cover snug against the camper's profile, reducing flapping and chafe during windy storage conditions.
The integrated rope channels and included toss bag let you route tie-down straps under the truck without crawling on the ground. Feed the bag across and use it to pull the rope through -- a small feature that makes a real difference on cold mornings or in tight storage spaces.
PolyPro3 is Classic Accessories' three-layer laminate used on high-exposure surfaces (top and front). It is heavier and more water-resistant than PolyPro1, the single-ply material used on the sides where breathability matters more than waterproofing. This hybrid approach gives you a drier camper interior than a fully waterproof cover, which can trap condensation.
This cover is rated for campers up to 8 feet long and 8 feet wide. Measure your camper body -- not the full truck length -- before ordering. If your camper body exceeds either dimension, size up to avoid stress on the seams and fasteners.