• Manual brake release with detent handle and an additional locking lever. Enclosed in a rubber book cover.
• Motor brake to disengage at 9-14 VDC with manual override and locking lever.
• Mounting method: face mount.
• Fully sealed against splash.
• TENV configuration.
• Sleeve bearing motor and gear unit.
• Internal brushes.
• Grease lubrication.
• 12V DC permanent magnet parallel shaft or right angle gear motor duty cycle: Intermittent.
• Red wire lead +12V clock wise rotation.
• 400" lbs. of torque at 15 amps max and 15 RPMS/min.
• 500" lbs. minimum of holding torque on output shaft and must be able to back drive (manually override).
• Output shaft with 360" lbs. maximum.
• Stall current 55 amps minimum.
• 14 gauge leads and 12" long using UL or CSA listed 125 degree Celsius wire.
• Dimensions: See photos above.

Lippert Power Gear RV Slide Out Motor Assembly