When your pellet stove fails to light, the ignitor is the most common culprit. This is the correct OEM-spec replacement ignitor (part number 80619, also sold as NBK Parts 20118K) for a specific range of Golden Eagle, US Stove, and King pellet stoves. Swap it in with basic hand tools and restore reliable automatic ignition -- no guesswork on fitment.
The 80619 ignitor is a hot-rod style ceramic ignitor rated at 250 watts. It draws current to heat a ceramic element that ignites the pellet fuel in the burn pot. At 4 inches long and 3/8 inch in diameter, it fits the exact mounting geometry of the supported model list without modification. Male spade connectors make wiring reconnection straightforward.
This part is cross-listed under two numbers -- 80619 (United States Stove Company) and 20118K (NBK Parts). Both refer to the same component. Always verify your stove model from the list below before ordering.
Delivers the correct wattage to reliably ignite wood pellets in the burn pot without drawing excess current from the stove control board.
Male spade connectors match OEM wiring harness terminals -- no splicing or adapters needed for supported models.
At 4" long and 3/8" diameter, this ignitor is sized to drop into the ignitor port on supported models without drilling or modification.
Sold as US Stove 80619 and NBK Parts 20118K -- both are the same part, making it easy to cross-reference from service manuals or prior orders.
Confirm your exact model number before ordering. This ignitor fits the following pellet stoves:
Ignitor replacement is a DIY-friendly repair on most pellet stoves. The general process for these models involves: