When your HydroFlame 82DC furnace stops pushing heat, the blower motor is one of the most common failure points. The Atwood 32330 is the factory-spec direct replacement -- a 12V, 2450 RPM motor engineered to restore your RV furnace to full operation without modification. It replaces OEM part number PF-23129Q and is also sold under NBK part number 20274K.
The blower motor in your HydroFlame 82DC furnace runs continuously any time the burner is lit. Over time -- especially with dusty campground air and years of seasonal cycling -- the motor bearings wear, airflow drops, and eventually the furnace shuts down on a high-limit fault or fails to circulate heat altogether. The Atwood 32330 is the correct OEM-spec replacement that drops in without re-wiring or adapter brackets.
This motor is stocked as a service part for DIY repair and professional RV technicians alike. If your furnace runs but doesn't push adequate air, or cycles off prematurely due to overheating, replacing the blower motor is a logical first step before condemning the entire furnace assembly.
Designed specifically for HydroFlame 82DC series furnaces. Replaces Atwood OEM part PF-23129Q with no modifications required.
Runs on standard 12V DC house battery power -- compatible with both lead-acid and lithium battery systems common in modern RVs.
Factory-matched rotation speed ensures correct combustion airflow and heat distribution through the furnace heat exchanger.
At 2.5 lbs., this motor is easy to handle during installation in tight furnace compartments typical of travel trailers and motorhomes.
This motor is purpose-built for the Atwood HydroFlame 82DC series forced-air propane furnaces. The 82DC designation covers a family of furnaces commonly installed in travel trailers, fifth wheels, and Class A and Class C motorhomes from multiple manufacturers. If your furnace nameplate or documentation references the 82DC series, this is the correct replacement motor.
Replacing the blower motor on an 82DC series HydroFlame furnace is a common DIY repair for RV owners with basic mechanical skills. The furnace typically needs to be pulled from its compartment bay or accessed from a service panel. Disconnect 12V power and the propane supply before beginning any work.