When your pellet stove stops pushing warm air into the room, a failed convection blower is one of the most common culprits. The Enviro 50-2481 is a direct OEM replacement motor designed to restore proper heat distribution to specific Regency, Enviro, and Vista Flame pellet stove models -- no modifications or adapters required.
The convection blower motor is the component responsible for circulating heated room air across your stove's heat exchanger and out into your living space. When it fails or degrades, heat output drops sharply even though the stove may appear to be burning normally. This Enviro-sourced replacement uses the correct mounting configuration, shaft size, and electrical specs for the stoves listed below -- making it a straightforward swap for a DIY-capable owner or a technician performing a service call.
This motor is also cataloged as NBK Parts number 20296 and directly replaces three Enviro part numbers: 50-2481, 50-2064, and 50-2414. If your current part carries any of those numbers on its label, this is the correct replacement.
Engineered to Enviro specifications. Correct mounting footprint, shaft dimensions, and wiring for listed models -- no fabrication needed.
Supersedes Enviro 50-2481, 50-2064, and 50-2414. Cross-reference your old motor's label before ordering.
Runs on standard North American household current. No step-down transformer or special wiring required.
Backed by a full one-year warranty from Enviro against defects in materials and workmanship.
This motor is confirmed to fit the following pellet stove models. If your model is not listed, do not assume compatibility -- verify your current part number against the three Enviro numbers this motor replaces.
Not sure if the blower motor is the problem? Common signs of convection blower failure in these pellet stove models include:
This is a straightforward motor swap for anyone comfortable with basic appliance repair. General steps for most listed models include disconnecting power, accessing the blower compartment, noting the motor's wire connections, unbolting the motor from its mounting bracket, and installing the new unit in reverse order. Always allow the stove to cool completely before beginning any service work.