When your Thelin pellet stove fails to light, the igniter is almost always the first component to check. This OEM-spec replacement igniter restores reliable automatic ignition to your Thelin stove -- no jury-rigging, no adapters, no fitment guesswork. Rated at 250W and built to the same dimensions as the original, it drops straight in with female connectors that match the factory wiring harness.
A failed igniter is one of the most common service issues on pellet stoves. The igniter heats the firepot to ignite the pellets automatically at startup. When it burns out -- which happens eventually with any resistance heating element -- the stove will attempt to start, auger in pellets, and run the combustion blower, but no flame will establish. The result is a stove that shuts down on an ignition fault and a firebox full of unburned pellets.
Thelin part number 00-0035-0125 (also sold under NBK Parts number 20211) is the correct direct replacement igniter for the affected Thelin stove models listed below. At 3-1/2 inches long and 3/8 inch in diameter, it matches the factory igniter geometry exactly, and the female connectors plug directly into the existing harness without modification.
Rated at 250 watts for fast, reliable pellet ignition at startup -- consistent with the original factory spec.
3-1/2 in. length and 3/8 in. diameter match the factory igniter exactly for a no-modification installation.
Pre-terminated female connectors plug into the existing stove wiring harness -- no splicing or rewiring required.
Fits Thelin Parlour, Tiburon, Providence, Gnome, and Echo Comstock pellet stove models.
This igniter is designed and confirmed to fit the following Thelin pellet stove models:
Igniter replacement on Thelin pellet stoves is a serviceable DIY repair for owners comfortable with basic appliance maintenance. The general process involves removing the burn grate or firepot access panel, disconnecting the two female connectors from the old igniter, extracting the element from its mounting bracket, and reversing the steps with the new part. Always allow the stove to cool completely before beginning any service work.
Not sure if the igniter is actually the problem? Common signs of igniter failure include:
A working 250W igniter should show a measurable resistance (typically in the range of 50-60 ohms for a cold element at this wattage class). An open-circuit reading confirms the element has failed and replacement is needed.