When your pellet stove stops feeding fuel, the auger motor is one of the first components to check. The Englander PU-047040 is a direct-replacement auger motor built for a wide range of Englander and rebranded pellet stove models. It arrives fully assembled with male spade connectors ready to plug into your existing wiring harness -- no splicing required. Counter-clockwise rotation, 120V/60Hz operation, and USA manufacture make this a reliable, drop-in fix to get your stove back up and running.
The auger motor is the heartbeat of your pellet stove. It turns the auger shaft at a precisely controlled rate to feed wood pellets from the hopper into the burn pot at a steady, even pace. When this motor fails -- or begins to slip, grind, or stall -- your stove will produce inconsistent heat, generate error codes, or shut down entirely. A worn motor is a common cause of pellet jams and incomplete combustion.
The PU-047040 is engineered to Englander's OEM specifications, matching the original motor's rotation direction, RPM output, and electrical ratings. It mounts directly to the auger shaft in the same position as the factory part, and the pre-attached male spade connectors align with the stove's wiring harness for a clean, tool-minimal installation. Also sold under the NBK Parts number 20131.
Engineered to match Englander factory specifications for rotation direction, voltage, and mounting. No modifications needed.
Ships ready to install. Male spade connectors are pre-attached and align directly with the stove's wiring harness.
CCW rotation is required for correct auger feed direction. Installing the wrong rotation will jam the auger and damage the shaft.
Domestic manufacture supports consistent quality control and part availability for Englander stove owners.
This motor fits a large cross-section of Englander-manufactured pellet stoves, including units sold under the 55-SHP and 55-TRP private-label programs. Verify your model number on the stove's data plate before ordering.
The PU-047040 mounts to the auger shaft using the existing hardware on the stove. Disconnect power before beginning any service work. Remove the old motor by disconnecting the spade connectors and unbolting the motor from its bracket. Slide the new motor onto the auger shaft, secure with the original fasteners, and reconnect the spade terminals. Restore power and run the stove on a low feed setting to confirm smooth, quiet auger operation.