Tired of kicking rubber pads and wood blocks under your jacks every time you set up camp? The SnapPad XTRA snaps directly onto the round or square foot of your RV's stabilizer or leveling jack and stays there -- drive-ready, camp-ready, always in position. No loose hardware rattling in the basement. No forgotten pads left at the last campsite. One pad, one jack, permanently attached until you choose to remove it.
The SnapPad XTRA (part number XTRSP1) is designed for RV stabilizer and leveling jacks with a square foot pad measuring approximately 4 inches across the flat face. The XTRA's larger 11x11-inch footprint spreads the load over a significantly wider surface area than the bare jack foot alone -- reducing ground penetration on soft soil, gravel, grass, and asphalt-patched campground pads that tend to give way under point loads.
The snap-on retention system grips the existing jack foot firmly enough to stay in place at highway speeds, through gravel roads, and across washboard. No bolts, no adhesive, no modification to your jack required. Yet the pad releases cleanly for replacement when worn -- no tools needed.
This listing is for a single pad (1 pack), so you can replace one worn pad, add coverage to a single jack, or mix-and-match across a rig that uses different jack foot sizes at different corners.
Snaps directly onto the jack foot and stays attached during travel, never left behind at the campsite.
Spreads jack load across 121 square inches to prevent sinking on soft or uneven ground.
Installs by hand -- just press onto the jack foot until it snaps. Removes the same way when replacement is needed.
Sold as 1 pad so you can replace a single worn pad or customize pad size per jack without buying a full set.
SnapPad pads are injection-molded from a durable rubber compound that grips the jack foot through mechanical interference -- a molded collar on the inside of the pad wraps around the foot perimeter and locks in place. The grip is firm enough to survive road vibration but designed to release without damaging the jack when you pull the pad off by hand.
The XTRA designation in the SnapPad lineup refers to pads built for jacks with a square foot face -- as opposed to the round-foot jacks used on some older or European-style rigs. If your jack has a flat, roughly square plate at the bottom (common on many Lippert, BAL, and Atwood stabilizer jack assemblies), the XTRA series is the correct SnapPad family to choose.
Because SnapPad sizes are matched to specific jack foot dimensions, measure your existing jack foot before ordering. The XTRSP1 is sized for square feet approximately 4 inches across. SnapPad offers other XTRA SKUs for different foot sizes, so confirm fit before purchasing additional pads.
The 11x11-inch base distributes the downward force of a loaded stabilizer jack across 121 square inches. On soft ground -- wet grass, sand-heavy soil, or sun-softened blacktop -- this wider base dramatically reduces the tendency of the jack foot to punch through the surface, which can lead to an unlevel rig and jack damage.
The SnapPad XTRA XTRSP1 is engineered for stabilizer and leveling jacks that terminate in a square foot -- specifically those with a foot face of approximately 4 inches per side. Common compatible applications include:
SnapPad is NOT a universal one-size-fits-all pad. Verify your jack foot shape (round vs. square) and foot face dimension before ordering. If your rig uses a round-foot jack, SnapPad makes a separate round-foot series. If your square foot is larger or smaller than 4 inches, check SnapPad's full XTRA lineup for the correct size variant.
SnapPad manufactures pads in several families to match different jack foot styles:
The XTRSP1 occupies the core position in the XTRA family -- right-sized for the most common square-foot stabilizer jacks sold on American-market travel trailers and fifth wheels over the last two decades.