Carefree of Colorado R001848 Roller Tube Attach Clips with Retaining Rings for Latitude Awnings -- Set of 2

OEM Roller Tube Hardware for Carefree Latitude Awnings

The roller tube attach clip set is a small but critical component in the Carefree Latitude awning system. The e-clips with tabs snap into the grooves on the roller tube end cap stubs, while the retaining rings provide a secondary lock that prevents the tube from walking off the pivot point during travel or deployment. Without these clips in good condition, the roller assembly can shift or separate from the arms -- leading to fabric damage or awning failure on the road.

This is a direct OEM part from Carefree of Colorado, ensuring correct fitment for Latitude awnings without modification. Each set includes enough hardware for one complete roller tube installation: two clips and two rings, one for each arm end.

When to Replace These Clips

Roller tube attach clips are often overlooked during awning inspections. Check these components if you notice:

• The roller tube shifts laterally during extension or retraction
• One end of the awning fabric appears lower than the other
• Clicking or popping sounds when deploying the awning
• A clip or ring is visibly cracked, bent, or missing entirely
• You are replacing an awning arm or performing a full roller assembly rebuild

Compatibility Notes

Part number R001848 is designed for the Carefree Latitude awning line, covering both single stage and dual stage configurations. If you are unsure whether your awning is a Latitude model, check the label on the awning head rail or the arm casting -- Carefree typically stamps or labels the model series there. This clip set is not a universal fit for all Carefree awnings; other Carefree lines such as the Pioneer or Fiesta use different roller tube hardware.

Installation Overview

Replacing the roller tube attach clips is a straightforward task requiring basic hand tools. In most cases:

• Lower or remove the roller tube from the awning arms
• Use a small flathead screwdriver or pick to remove the old e-clip from the groove on the tube end stub
• Slide off the old retaining ring if present
• Seat the new retaining ring, then snap the new e-clip into the groove until it is fully seated with the tab engaged
• Repeat for the opposite end
• Reinstall the roller tube onto the awning arms and test full extension and retraction

Product Specifications

What's in the Box

Fitment