This is the genuine Carefree of Colorado replacement motor cover for the right side of Altitude series RV awnings. If your existing cover is cracked, faded, or missing, this OEM part restores full protection for your awning motor against UV exposure, road spray, rain, and debris -- keeping your awning system operating reliably for seasons to come.
The motor cover on a Carefree Altitude awning does more than finish the look -- it shields the electric motor and wiring from the elements that degrade performance over time. UV rays, rain intrusion, and road grime are common causes of premature motor failure on exposed awning assemblies. Replacing a damaged or missing cover is a simple, low-cost repair that can prevent a much more expensive motor replacement down the road.
Part number R001931-006 is specifically engineered for the right-hand side of the Altitude awning arm assembly. It is not interchangeable with the left-side cover. This is a direct-fit OEM replacement -- no trimming, no adaptation, and no drilling required.
Designed exclusively for the right arm of Carefree Altitude awning systems. Confirm your awning arm side before ordering.
Genuine Carefree of Colorado part -- same material and geometry as the factory-installed cover. No fitment guesswork.
Protects the awning motor from UV degradation, rain, road spray, and dust accumulation that leads to motor failure.
Clips or fastens directly onto the existing Altitude arm housing. No special tools required for most installations.
Awning side orientation is determined by standing outside the RV, facing the side wall where the awning is mounted. The right arm is on your right as you face the coach. This matches standard Carefree of Colorado terminology for Altitude awning arm assemblies. If you need the opposite side, look for the left-side companion cover in our Carefree parts selection.
The Altitude awning line from Carefree of Colorado features a streamlined, low-profile arm design with an integrated electric motor for one-touch deployment. The motor cover is a structural part of the arm end cap assembly and is retained by the arm's existing fastener pattern. Replacement requires removing any screws or clips securing the old cover, then seating the new cover and re-securing the fasteners.
R001931-006 is designed for the Altitude series specifically. It is not compatible with Carefree Spirit, Pioneer, Fiesta, or Omega awning models, which use different arm end cap geometries. Check your awning's label or existing part number before purchasing.