Stop walking to your water pump every time you need to cycle it on or off. The Remco 901-RC01-R puts full control at your fingertips from up to 75 feet away, with a sealed, weatherproof housing built to handle the dust, vibration, and moisture that come with life on the road.
The 901-RC01-R is a dedicated remote on/off switch designed and rated specifically for Remco RV water pumps in the 1.0 GPM to 5.3 GPM flow range -- covering the majority of Remco's 12V pump lineup. Whether your pump is mounted under a dinette, in a basement compartment, or tucked into a tight wet bay, this remote lets you power it on and off without crouching, reaching, or disconnecting any plumbing.
The switch ships with a lanyard-style remote, heavy-duty 12 AWG wiring, and a standard SAE 2-pin connector for a clean, plug-and-play connection directly to a compatible Remco pump's wiring harness. No relay, no splice -- just plug in and mount the switch where it's convenient.
Dust, moisture, and debris are blocked by the remote's sealed enclosure, keeping contacts clean in outdoor and under-floor environments.
Control your pump from up to 75 feet away -- plenty of range for most RV sites, outdoor kitchens, or extended hose setups.
Built-in LED confirms at a glance whether the pump is powered on, eliminating guesswork when the pump is out of earshot.
20-amp-rated 12 AWG wire handles the full load of Remco's higher-output pumps without voltage drop or heat buildup at the connector.
The SAE 2-pin connector is designed to mate directly with Remco's standard pump wiring harness. No additional adapters are needed for compatible Remco pumps in the 1.0-5.3 GPM range. Check your pump's wiring harness for the matching SAE connector before ordering.
This switch is rated for any Remco 12V DC water pump producing 1.0 GPM to 5.3 GPM. That range includes popular Remco models in the 55, 65, 5.3, and 3.0 series -- if your pump is a 12V Remco and falls within that GPM window, the 901-RC01-R is the correct remote switch. If you are unsure of your pump's GPM rating, check the label on your pump housing or your RV's appliance documentation.
This is a low-voltage 12V DC remote switch -- it is not rated for 120V AC or 24V DC systems. Route the 12 AWG wire away from sharp edges, exhaust components, and moving parts. The switch should be mounted in an accessible location that allows the LED indicator to be visible during operation. Do not exceed the 20A current rating.