Single recycled rubber cap/topper for compatible 8-1/2" x 8-1/2" plastic stacker blocks, adding grip, stability, protection, and extra height during RV leveling setup.
The SnapPad CAP1, also known as The Cap, is a recycled rubber topper designed for compatible 8-1/2" x 8-1/2" plastic stacker blocks. It helps create a better contact surface between a metal jack foot, tongue jack, stabilizer, or support point and the plastic stacker block underneath.
Plastic stacker blocks can be slippery or brittle under load. The Cap adds a rugged rubber contact layer to help improve grip, increase stability, reduce sliding, and protect the plastic block from wear and tear during RV setup.
Fits on top of compatible 8-1/2" x 8-1/2" plastic stacker blocks
Made from durable recycled rubber for outdoor RV leveling use
1" thick cap adds approximately 1/2" to the stacker setup
Helps improve traction and stability between jack foot and block
SnapPad CAP1 is not a permanent snap-on jack foot pad and is not selected by RV jack foot size. It is a rubber topper for compatible 8-1/2" x 8-1/2" plastic stacker blocks. Compatible stacker brands listed by SnapPad include Tri-Lynx®, Camco®, Homeon Wheels®, Dolity®, RoBloc®, Yosager®, Juegoal®, ZXDIN3®, and many more. Always verify the actual stacker block size and shape before ordering.
Before Starting: Confirm the plastic stacker block size before use. The Cap is intended for compatible 8-1/2" x 8-1/2" plastic stacker blocks and should be placed on a stable, properly built stack. Basic Use Steps: 1. Confirm Compatibility: Verify the stacker block is a compatible 8-1/2" x 8-1/2" plastic block. 2. Inspect the Block: Check the stacker block for cracks, damage, warping, or debris before use. 3. Build the Stack: Place the stacker blocks on stable ground and build the stack to the needed height. 4. Add The Cap: Place the SnapPad CAP1 on top of the compatible stacker block. 5. Center the Load: Make sure the jack foot, tongue jack, stabilizer, or support point is centered on The Cap. 6. Apply Load Slowly: Lower the jack or support point gradually while checking for shifting or movement. 7. Confirm Stability: Make sure the full setup remains centered, flat, and stable before relying on it.
Package Contents: • 1 SnapPad CAP1 The Cap rubber stacker block topper NOT Included — May Also Need: • Plastic stacker blocks • RV jack pad or jack foot • Leveling bucket • Wheel chocks • Additional CAP1 units for multiple stacker setups This listing is for one SnapPad CAP1 rubber cap/topper only. Stacker blocks, jacks, buckets, and chocks are sold separately unless otherwise stated.
To confirm compatibility before ordering, have the following ready: • Stacker block dimensions • Brand/model of plastic stacker block, if known • Photos of the stacker block being used • Number of support points needing a cap/topper • Type of jack or support point being placed on top of the stack • Type of campsite surfaces commonly used: gravel, dirt, grass, concrete, or asphalt Why this matters: SnapPad CAP1 is matched to the plastic stacker block size, not directly to the RV jack foot. Regular SnapPad jack pads are selected by jack foot size and shape, while CAP1 is selected by the stacker block size.
Match SnapPad CAP1 by plastic stacker block size and shape. This product is not the same as a permanent SnapPad selected by RV jack foot shape and size.
If the leveling setup still shifts, slips, or feels unstable, check ground condition, stacker block condition, jack placement, wheel chocking, and overall RV leveling procedure before adding more height.