Recycled rubber tongue jack wheel dock with two engineered slots for standard trailer jack wheels, helping reduce shifting, rolling, sliding, and sinking while parked.
The SnapPad DONUT1, also known as The Donut, is a recycled rubber wheel dock designed for trailer tongue jack wheels. It helps hold the tongue jack wheel in place while parked, reducing unwanted rolling, shifting, sliding, or sinking during trailer setup.
The Donut includes two engineered docking slots for different tongue jack wheel sizes and is designed for standard jack wheels up to 6" x 2-1/4" and up to 8" x 2-1/4". It is a simple support accessory for boat trailers, utility trailers, travel trailers, and popup campers that use a wheel-style tongue jack.
Designed to hold standard trailer tongue jack wheels in place
Two docking slots support different common tongue jack wheel sizes
Made from durable recycled rubber for outdoor trailer setup use
Helps reduce wheel movement, sliding, rolling, and sinking while parked
SnapPad DONUT1 is not a permanent snap-on jack foot pad and is not selected by flat jack foot size. It is a wheel dock for trailer tongue jacks with compatible wheel sizes. This product is designed for standard tongue jack wheels up to 6" x 2-1/4" and up to 8" x 2-1/4". Confirm the wheel diameter and width before ordering.
Before Starting: Confirm the tongue jack wheel diameter and width before use. The Donut is intended for compatible wheel-style trailer tongue jacks and should be placed on stable ground. Basic Use Steps: 1. Confirm Wheel Size: Verify the tongue jack wheel is within the compatible size range. 2. Choose Stable Ground: Place The Donut on firm, level ground whenever possible. 3. Select the Slot: Use the docking slot that best matches the jack wheel size. 4. Position the Wheel: Center the tongue jack wheel in the selected slot. 5. Lower Slowly: Lower the tongue jack gradually while confirming the wheel remains seated. 6. Check Stability: Make sure the trailer, jack wheel, and Donut remain centered and stable. 7. Chock as Needed: Use wheel chocks and safe trailer parking practices before unhitching or leaving the trailer parked.
Package Contents: • 1 SnapPad DONUT1 The Donut rubber tongue jack wheel dock NOT Included — May Also Need: • Trailer tongue jack • Tongue jack wheel • Wheel chocks • Leveling blocks or stabilizer pads • Additional support accessories for soft or uneven ground This listing is for one SnapPad DONUT1 wheel dock only. Trailer jack, jack wheel, chocks, and other support accessories are sold separately unless otherwise stated.
To confirm compatibility before ordering, have the following ready: • Tongue jack wheel diameter • Tongue jack wheel width • Trailer type: boat trailer, utility trailer, travel trailer, or popup camper • Photos of the tongue jack wheel, if unsure • Type of parking surface commonly used: gravel, dirt, grass, concrete, or asphalt Why this matters: SnapPad DONUT1 is matched to the tongue jack wheel size, not to a flat jack foot. Regular SnapPad jack pads are selected by jack foot size and shape, while The Donut is selected by wheel diameter and width.
Match SnapPad DONUT1 by tongue jack wheel diameter and width. This product is not the same as a permanent SnapPad selected by flat RV jack foot shape and size.
If the tongue jack wheel still shifts, sinks, or feels unstable, check ground condition, wheel size, trailer wheel chocking, jack condition, and overall trailer parking setup before adding more height.