Single permanent recycled rubber jack pad for compatible 6" round RV jack feet, adding grip, stability, surface protection, and approximately 1" of thickness.
The SnapPad Mini 6 MN6SP1 is a single permanent jack pad designed for compatible 6" round RV jack feet. Once installed, the pad stays attached to the jack foot, eliminating the need to place a loose pad under that jack during normal setup.
Made from durable recycled rubber, this compact SnapPad helps increase the jack’s landing surface area, improve grip, reduce vibration, and protect both the jack foot and parking surface. It is commonly used on travel trailers and Class C motorhomes when equipped with compatible 6" round jack feet.
Designed for compatible 6" round jack feet
Snaps onto the jack foot and stays attached after installation
Adds approximately 88% more surface area to the jack foot
Made from durable recycled rubber for outdoor RV use
SnapPad MN6SP1 is selected by jack foot size and shape, not by RV brand alone. This single pad is intended for compatible 6" round jack feet. Always measure the actual jack foot at its widest point before ordering. Compatible rig types commonly listed for this Mini 6 pad include travel trailers and Class C motorhomes. Do not assume fit based only on the RV make, model, year, or brand name.
Before Starting: Measure the jack foot before installation. This pad is designed for compatible 6" round jack feet only. Basic Installation Steps: 1. Measure the Jack Foot: Confirm the jack foot is round and measures 6" across at its widest point. 2. Check Clearance: Verify the installed pad will not interfere with tires, suspension parts, frame brackets, exhaust, or other nearby components when the jack retracts. 3. Inspect the Foot: Check for bent metal, heavy rust, damage, or unusual jack foot shape that may affect fit. 4. Clean the Foot: Remove dirt, gravel, grease, or loose debris from the jack foot. 5. Position the Pad: Place the Mini 6 pad under the jack foot and align it evenly. 6. Lower the Jack: Use the jack or leveling system to press the foot into the pad until fully seated. 7. Confirm Attachment: Visually inspect that the pad has snapped securely around the jack foot. 8. Test Retraction: Retract the jack and confirm the installed pad clears all nearby components.
Package Contents: • 1 SnapPad Mini 6 MN6SP1 permanent jack pad for compatible 6" round jack feet NOT Included — May Also Need: • Additional SnapPads for other jack feet • Leveling jacks or jack feet • Separate leveling blocks or base pads • Wheel chocks • Replacement jack foot hardware This listing is for one SnapPad Mini 6 jack pad only. Order the quantity needed for each compatible 6" round jack foot.
To confirm compatibility before ordering, have the following ready: • RV make, model, and year • Leveling or stabilizer system brand/model, if known • Photos of the jack foot from below • Measurement across the jack foot at its widest point • Confirmation that the jack foot is round • Clearance around the jack foot when fully retracted Why this matters: SnapPads are selected by jack foot shape and jack foot size. Even on commonly compatible RV brands, jack foot sizes can vary by model year, chassis, leveling system, stabilizer system, and previous repairs.
Match SnapPad MN6SP1 by 6" round jack foot size and available clearance. RV brand or rig type alone is not enough to confirm fitment.
If a SnapPad does not seat correctly or clearance is tight, stop and recheck jack foot measurements, pad model, installation orientation, and nearby component clearance before operating the leveling system.