Keep your Whitfield pellet stove burning clean and efficiently with this direct replacement draft inducer motor. The 12150011 restores proper combustion airflow and exhaust evacuation -- two functions that are critical to safe, reliable pellet stove operation. Includes the mounting gasket for a complete installation.
The draft inducer -- sometimes called the combustion blower -- is responsible for pulling exhaust gases out of the firebox and venting them safely through the flue. When this motor weakens or fails, your stove may produce smoke, fail to light, shut down on fault codes, or vent improperly. The Whitfield 12150011 is built to OEM specifications to restore correct airflow balance without modification.
This motor matches the original mounting footprint with a 5.75-inch plate diameter and ships with a replacement gasket, so you have everything needed to complete the swap. It is also cross-listed under NBK Parts number 20136, which is a common way this part appears in service manuals and distributor catalogs.
Engineered to match original Whitfield specifications -- no adapters, drilling, or fabrication required for compatible stove models.
Comes with a mounting gasket so the combustion chamber seal is restored at the same time as the motor, reducing the risk of exhaust leaks.
Motor rotates clockwise (when viewed from the shaft end) to match original impeller and blower wheel orientation on Whitfield units.
Runs on standard 115V / 60Hz household current -- no voltage conversion or special wiring required for North American pellet stove installations.
The draft inducer is a small but critical motor that runs during every burn cycle. It operates in a high-temperature environment with exposure to combustion gases, particulates, and thermal cycling. Over time, motor bearings wear, capacitors degrade, or windings fail -- all of which cause reduced airflow, noisy operation, or complete stall.
Common symptoms of a failing draft inducer include: the stove failing to ignite, error codes related to pressure switch or combustion airflow, unusual grinding or rattling noise from the combustion blower compartment, or visible smoke rollout from the firebox door.
Replacement is a straightforward process for someone comfortable with basic appliance service. The stove must be fully cool and disconnected from power before beginning. The combustion blower is typically accessed from the rear or bottom panel of the stove. The motor mounts to a bracket or firebox wall with fasteners through the plate. The blower wheel (impeller) transfers from the old motor shaft to the new one.