Route your RV central vacuum system exactly where you need it. The Dirt Devil 5501-W 90-degree sweep tee gives you a clean, secure three-way connection in 2-inch PVC vacuum pipe -- ideal for custom inlet placement, vac pan accessory installation, or any layout that requires a directional branch off the main trunk line.
Designed specifically for the Dirt Devil CV1500 RV central vacuum system and compatible with other 2-inch schedule-40 style central vacuum pipe networks, the 5501-W sweep tee lets you branch a vacuum line at 90 degrees without sharp bends that kill suction. The swept interior geometry maintains airflow through all three ports so you don't sacrifice performance at the turn.
Made from high-grade Plastiflex durable PVC, this fitting is built to handle the sustained low-pressure airflow demands of a residential or RV central vacuum installation. It accepts standard 2-inch OD vacuum pipe at all three inlets and creates a firm, slip-fit connection that can be solvent-cemented for a permanent, airtight joint.
All three ports accept standard 2-inch central vacuum PVC pipe or fittings, giving you full flexibility in run direction and branch layout.
Gradual sweep geometry reduces turbulence and pressure drop at the bend, preserving suction at the inlet end of the run.
High-grade, impact-resistant PVC rated for central vacuum applications -- will not collapse, warp, or degrade under normal vacuum pressures.
Slip-fit sockets accept standard PVC vacuum pipe for solvent-cement bonding, eliminating suction leaks at the joint.
The 5501-W sweep tee is the right choice any time you need to:
While designed for the Dirt Devil CV1500 RV Central Vacuum System, the 5501-W uses standard 2-inch central vacuum pipe sizing and is compatible with other brands that use the same pipe standard. If your system runs 2-inch OD vacuum pipe, this fitting will integrate cleanly into your layout.
This fitting uses standard PVC slip-fit sockets. For a permanent installation, clean the pipe ends, apply PVC primer, and use PVC solvent cement rated for low-pressure or central vacuum applications. Dry-fit all connections before cementing to confirm layout direction. The swept inlet is typically oriented toward the incoming main run; the 90-degree branch port connects to the inlet valve or vac pan drop.
A sweep tee differs from a standard tee in that the branch port enters the main flow path at a gradual curve rather than a sharp 90-degree stub. This reduces airflow restriction at the junction, which matters in central vacuum systems where maintaining consistent negative pressure throughout the pipe run is critical to pickup performance at each inlet.
This fitting is designed for central vacuum (low-pressure airflow) applications only. Do not use it in plumbing, compressed air, or any pressurized service.
After installation, run the central vacuum unit and hold your hand near each cemented joint to feel for air leaks. A properly cemented 2-inch PVC slip joint should be fully airtight. Any detectable airflow at a joint indicates incomplete cement coverage and should be addressed before closing walls or cabinetry.