Keep your RV awning locked down and damage-free in wind, rain, and shifting terrain. The Camco 42593 Awning Stabilizer Kit uses spiral ground stakes and tension springs to eliminate the flapping, sagging, and water pooling that wear out awning fabric and hardware over time. Works in firm ground and sandy or loose soil alike.
An unsecured awning is a liability. Even moderate wind gusts can cause the fabric to flap hard enough to stress the roller tube, tear the leading edge, or allow rainwater to pool and sag. The Camco 42593 kit addresses all three problems with a simple four-component system that installs in minutes and stores flat when not in use.
The spiral stake design is the key differentiator here. Unlike straight pin stakes that pull out of soft or sandy soil under repeated tension, the corkscrew thread bites into loose ground and resists extraction in multiple directions. That makes this kit a solid choice for campgrounds with sandy sites, desert terrain, or rain-softened ground where conventional stakes fail.
Two 12-inch spiral-thread anchors twist into the soil for superior holding power compared to straight pin stakes -- especially in sandy or loose ground.
Two 7-inch tension springs absorb gusts and load shifts, keeping constant even pressure on the awning without over-stressing the fabric or roller arm.
Two 10-inch nylon straps and two tension buckles allow quick length adjustment to fit different awning heights and stake angles.
Compatible with all standard RV awning sizes and brands. No drilling or modification required -- attaches to existing awning hardware.
RV awnings are vulnerable to three main weather-related failure modes. This kit addresses all of them:
Setup takes roughly five minutes with no tools required beyond twisting in the stakes by hand (or with a screwdriver through the top loop for added torque in firm ground):