Keep your Eclipse series awning operating safely and securely with the correct OEM shock mounting hardware. Part R001253 is the factory-spec replacement for worn, broken, or missing shock mount components on Carefree Eclipse awnings, restoring proper tension, arm movement, and weather resistance without modification.
Carefree of Colorado's Eclipse awning series uses a gas shock assist system to control arm extension and retraction. The shock mounts -- the hardware that anchors each shock to the awning arm and wall bracket assembly -- are exposed to constant UV, vibration, and road stress. When a mount cracks, strips, or loses its retention, the shock can detach and the awning arm may drop or fail to hold its open position.
Part number R001253 is the manufacturer's designated replacement shock mounting hardware for the Eclipse series. Using the correct OEM part ensures proper alignment of the shock travel, correct load distribution across the arm, and a secure fit that aftermarket or improvised hardware cannot reliably duplicate.
Engineered specifically for Carefree Eclipse series awning arms -- no drilling, grinding, or adapter required for a proper installation.
Built to handle continuous outdoor exposure including UV, rain, road vibration, and temperature cycling common in RV use.
Restores correct shock anchoring so the awning arm extends and retracts with proper tension and holds its set position reliably.
Replaces the existing mount hardware at the shock attachment point -- no special tools required beyond basic hand tools for most installations.
On Carefree Eclipse awnings, the gas shock absorbers are retained at each end by mounting hardware -- typically a bracket, pin, clip, or stud assembly depending on the specific arm configuration. R001253 is that retention and mounting hardware. It is not the shock itself. If your shock body is intact but the mount point is damaged or missing, this is the part you need. If the shock itself is bent or has lost gas pressure, the shock assembly will need to be replaced separately.
Installation involves removing the existing shock from the damaged mount point, transferring or replacing the hardware at the anchor location, and reinstalling the shock. On most Eclipse arms this is a straightforward task with standard hand tools. Ensure the awning is fully retracted and secured before beginning any shock or arm hardware work. Do not work under an unsupported open awning.