Flexible accordion-style sewer hose support that lifts and grades your 3" sewer hose for gravity drainage. Curves around obstacles, holds position without creeping closed, and collapses to 6" for storage. No straps, no staples, no assembly. Stackable with other Sidewinder units.
The Camco Sidewinder is the most widely used sewer hose support in the RV industry. Without support, a sewer hose lying flat on the ground pools in low spots — trapping waste and slowing or stalling drainage. The Sidewinder cradles the full length of the hose in a sloped accordion-style support that creates a consistent downward grade from the RV dump valve to the sewer inlet, keeping waste moving by gravity throughout the drain cycle.
The 43031 is the 10-foot version — the right choice for shorter hookup distances where the full 15-foot or 30-foot models would be more than needed, or as an add-on unit to extend an existing Sidewinder run. The flexible segmented design lets it curve around campsite obstacles that would stop a rigid support. Deep cradles hold the 3" hose without straps, snap-fit hinges keep the accordion extended under load, and the carrying handle clips around the unit when packed.
Built-in slope from 9-3/4" at the high end to 6-3/4" at the low end creates consistent downhill flow
Flexible accordion bends around pads, curbs, and irregular campsite layouts that rigid supports can't navigate
Snap-fit hinges hold the accordion open at the deployed position — no straps or props needed
Compact folded length — carrying handle clips around the unit for one-hand storage
Takes about 60 seconds to deploy: 1. Unclip the handle and remove from the compressed unit 2. Place the high end (9-3/4") nearest the RV and extend the accordion toward the sewer inlet 3. Curve around any obstacles as needed — the flexible design holds its shape 4. Lay the sewer hose into the cradles from high end to low end 5. Connect hose to dump valve and sewer inlet as normal To extend beyond 10 ft: Connect another Sidewinder end-to-end using the built-in snap connectors — the 43041 (15 ft) or 43061 (30 ft) can be added to reach longer hookup distances.
• 1x Camco 43031 Sidewinder 10-ft Sewer Hose Support • Carrying handle (clips around compressed unit) Other Sidewinder Sizes: • 43041 — Sidewinder 15-ft (collapses to 10") • 43061 — Sidewinder 30-ft All Sidewinder sizes connect end-to-end for extended runs.
The Sidewinder has a built-in slope — one end is taller than the other. Always place the taller end (9-3/4") at the RV dump valve and run toward the sewer inlet at the shorter end (6-3/4"). Installing it backwards creates a low point that traps waste rather than draining it. If the campsite sewer inlet sits higher than the RV dump valve, additional height from leveling blocks under the support may be needed.