A factory-quality interior ceiling assembly designed to work with most Coleman Mach rooftop air conditioners. This deluxe non-ducted unit puts manual controls front and center, delivers clean white trim that blends into standard RV interiors, and comes heat-ready so you can add a heat pump or heat strip without swapping out the ceiling box later.
When your original Coleman Mach ceiling assembly cracks, discolors, or simply stops working reliably, this 9430E715 Deluxe is the direct replacement to reach for. It is purpose-built for non-ducted installations -- meaning conditioned air is distributed directly through the ceiling box louvers rather than through a duct network. That makes it the correct choice for the vast majority of Class A, Class C, fifth-wheel, and travel trailer installations that use a single rooftop AC unit blowing into one open living space.
The "heat-ready" designation means the wiring harness and control provisions inside this assembly are already configured to support a heat pump rooftop unit or an electric heat strip add-on. You will not need to replace the ceiling assembly again if you upgrade your rooftop unit to a heat-capable model -- the wiring is already there.
Manual controls are located in the center of the unit, right where you expect them on a Coleman Mach system. Fan speed, mode selection, and temperature management are handled directly on the ceiling box rather than through a wall thermostat, which is standard for non-ducted single-zone setups.
Pre-wired to support heat pump or electric heat strip upgrades without replacing the ceiling box.
Delivers conditioned air directly through ceiling louvers -- no duct network required.
Fan speed and mode controls built into the center of the assembly for straightforward one-point operation.
Clean gloss white trim blends with standard RV interior ceilings. Replaces faded or damaged OEM assemblies.
This listing covers the complete interior ceiling assembly unit, which includes:
The rooftop condensing/evaporator unit is sold separately. Wall thermostats and heat strip kits are not included.
Non-ducted ceiling assemblies like the 9430E715 distribute air through the ceiling box directly into the room. If your RV has a duct network running to multiple vents throughout the coach, you need a ducted ceiling assembly instead. Most single-rooftop-unit RVs under 35 feet use the non-ducted style. Check your existing ceiling box -- if air comes out of the box itself rather than separate ceiling registers, this is the correct type.
A heat-ready ceiling assembly contains the additional wiring provisions, switch contacts, and control logic needed to operate a heat pump or resistance heat strip in the rooftop unit. If your current rooftop unit is a standard cool-only model, the heat-ready ceiling assembly will work fine -- the extra circuitry simply sits dormant. When you later upgrade to a heat-capable rooftop unit (such as a Coleman Mach 8 Heat Pump series), the ceiling box does not need to be replaced again.
While this assembly is designed to fit most Coleman Mach rooftop units, confirm your rooftop unit model number against Coleman Mach's compatibility chart. The ceiling box attaches to the interior side of the rooftop unit curb -- mismatched models can result in poor sealing, air leaks, or control wiring mismatches. Coleman Mach part number CMN9430E715 is the manufacturer reference for this assembly.