Keep your weight distribution system fully operational with the correct factory-spec hitch pin. The Eaz-Lift 48021 is the original equipment replacement pin for the Eaz-Lift 48054 Elite Bent Bar Weight Distribution Hitch, machined to the same 5/8" diameter as the part it replaces so no modification or adaptation is needed.
A worn, bent, or missing hitch pin compromises the entire weight distribution system. The spring bars cannot seat or pivot correctly without a properly fitting pin, which can lead to uneven load transfer and unsafe towing. Replacing it with the correct OEM-spec part restores the hitch to factory function immediately.
The 48021 is purpose-built for the Eaz-Lift 48054 Elite Bent Bar Weight Distribution Hitch -- not a universal pin, not an approximation. If your current pin shows visible wear, corrosion, or damage at the spring bar pivot points, swap it out before your next trip.
Exact replacement for the 48054 Elite Bent Bar system -- installs without modification.
Matches factory specification for correct spring bar seating and pivot function.
Backed by Camco's limited 90-day manufacturer warranty against defects.
Drop-in replacement -- no drilling, no adapters, no guesswork on sizing.
Weight distribution hitches work by transferring tongue weight forward through spring bars that pivot on -- or secure to -- a hitch head. The pin is the mechanical interface point for that pivot. If the pin is undersized from wear, cracked, or corroded, spring bar tension is applied unevenly, reducing the effectiveness of the weight distribution and potentially causing trailer sway.
Inspect the hitch pin every season and after any hard towing event (rough roads, emergency braking, off-pavement travel). Replacing a worn pin is a low-cost step that protects a much larger investment in your hitch system and trailer.
If you are unsure whether this pin fits your specific hitch head or bar assembly, compare the pin diameter (5/8") and the part number stamped or labeled on your existing hitch head before ordering.