 |
 |
 |
|
The Garnet 709-P3 SeeLevel Tank Monitoring System is designed for accurate level measurement of motorhomes and trailers with three holding tanks. This system monitors battery voltage, fresh, grey, and black water levels. The level in percent is shown on a three digit LED display. Added features for this model includes a 3-way pump switch on the display panel.- Monitors battery voltage, fresh water tank, grey water tank, and black water tank
- Includes Fresh Water Pump Switch
- Provides accurate tank level information using percentage of full readout
- Tanks are monitored using Garnet’s proprietary external level sensing technology
- This ends fouling problems caused by debris build-up in the holding tank
- Detailed diagnostic information monitors sender operation
- Measures tanks from 3.5" to 34" depending on the sensors you specify.
- 710-AR Sender (standard) 3.5" min to 10.5" max (stacked = 21")
- 710-ES2 Sender (optional) 5.5" min to 14" max (stacked = 25")
- 710-SS Sender (optional) 7" min to 14" max (stacked = 34")
- Tank senders connect to display via a common bus network topology which saves wiring costs
- Uses common industry connector for ease of installation and servicing
- Display requires 12 volts from the RV battery, the system will function from 11 volts to 16 volts
- Current drain is less than 200mA
- Panel Dimensions: 4" W x 2.8" H x 1" D
- Required Cutout Size: 3" W x 1.8" H
- Includes: (1) Display monitor, (3) 9″ 710-AR tank senders, (1) pigtail and mounting screws
- Limited 1 year manufacturer warranty
- See our SeeLevel Tank Monitor Comparison Guide to help you choose the right system for your RV.
Garnet 709-P3 SeeLevel II Tank Monitoring System
Seelevel 709-P3 Tank Monitoring System
Seelevel Sensor Installation
|
|
|
 |
|
 |
|
|
|
 |
|
 |
|
Additional Product Information
Display Mounting Panel: Black panel, approximately 4” wide by 2.8” high by 1” thick (102mm wide X 71mm high X 25mm deep). Panel screws to wall.
Power Requirements: Display requires 12 volts from the RV battery, the system will function from 11 volts to 16 volts. Current drain is less than 200mA.
Wiring: A single two wire conductor required from the display to the senders. All the senders are wired in parallel. 12 V power and ground required for display.
Pump Switch: The pump switch is rated for a maximum of 7.5 amps. The use of a relay is required if more than 7.5 amps is needed. We recommend using a 7.5 amp fuse inline with the switch.
|
|
|
|
|
|
|
