Keep your pellet stove lighting reliably with a direct-fit replacement igniter bracket. This Harman part 20524-2 (also listed as NBK Parts 20524-2) is the correct bracket for mounting the firepot igniter in select Harman and Heatilator Eco-Choice pellet stove models. When the original bracket corrodes, cracks, or loses its alignment, the igniter rod can shift out of position and cause hard-start or no-start conditions -- swapping this bracket restores proper igniter placement and reliable auto-ignition.
The firepot igniter bracket holds the hot-surface igniter rod at the correct angle and depth inside the firepot. Over time, the high heat and ash exposure inside a pellet stove firepot can degrade the original bracket, causing misalignment that leads to unreliable ignition. Harman part 20524-2 replaces the OEM bracket exactly, restoring factory geometry without any modification.
At 0.3 lbs., this is a compact, lightweight hardware item. Installation is a straightforward fastener-swap in most covered models -- no special tools required beyond basic hand tools.
Harman part 20524-2, also cross-referenced as NBK Parts 20524-2 for easy ordering verification.
Engineered specifically for Harman PB105, PF100 and Heatilator Eco-Choice BH105 and BA100 pellet stove models.
Weighs just 0.3 lbs. -- a small part that does a critical job positioning the igniter rod correctly inside the firepot.
Proper igniter alignment is essential for consistent auto-start. A worn or bent bracket is a common cause of ignition failures in these stove models.
This bracket is confirmed to fit the following pellet stove models. Verify your model number on the stove's rating plate before ordering.
If your pellet stove is experiencing any of the following, a damaged or misaligned igniter bracket may be the cause: