Give yourself the reach you need when connecting portable propane cylinders to your RV, grill, generator, or camp appliance. The JR Products 06-0142 is a 12-foot rubber LP gas extension hose with standard male and female cylinder thread ends -- no adapters required for most setups. UL and CSA listed for peace of mind at the campsite or in the field.
Running short on hose length when positioning a propane cylinder away from your rig or outdoor kitchen? The JR Products 06-0142 solves that with 144 inches -- a full 12 feet -- of 1/4-inch ID rubber LP gas hose. It threads directly onto standard QCC1/Type 1 or POL cylinder valves using its pre-installed male and female cylinder thread ends.
Built to handle the pressures typical of low-pressure LP appliance circuits, this hose is suited for use between a regulator and an appliance or between a cylinder and a secondary regulator. The rubber construction provides flexible routing around tight quarters while meeting UL and CSA safety certifications.
144 inches of reach lets you position cylinders farther from your coach, grill, or generator without improvised connections.
Male and female cylinder thread ends connect directly to most standard LP fittings -- no extra adapters needed for typical setups.
Safety-listed to UL and CSA standards, meeting the certification requirements expected by most campgrounds and RV service facilities.
1/4-inch ID rubber hose routes easily in tight spaces and holds up to outdoor conditions typical of RV and camping use.
Before installation, inspect both cylinder valve and regulator inlet threads for damage or debris. Hand-tighten the connection first, then snug with a wrench -- do not overtighten rubber-seated LP fittings. After connecting, perform a leak test using soapy water or an approved LP leak detector solution at all joints before opening the cylinder valve fully.