A direct OEM-replacement left-hand mounting bracket engineered for Lippert 2x2 and 2.5x2.5 electric slide-out room systems. Restores proper slide-out alignment and operation without modification. Cross-referenced to Jayco and Keystone part numbers for easy identification.
A damaged or worn mounting bracket is one of the most common causes of a slide-out room that binds, rubs, or fails to retract and extend smoothly. Lippert part 1059611 is the factory-correct left-hand bracket for electric slide-out systems built on the 2x2 and 2.5x2.5 tube-frame platforms -- among the most widely used slide-out architectures found in Jayco, Keystone, and other major RV brands.
At just 3 lbs and compact enough to store in a parts bag, this bracket is a straightforward swap that can be completed with basic hand tools. If your slide-out has developed a side-to-side wobble, is dragging on one corner, or shows visible wear or cracking at the mounting point, this bracket is likely the fix.
Designed specifically for Lippert 2x2 and 2.5x2.5 electric slide-out room systems -- no drilling or modification required.
Replaces Jayco part 0226439 and Keystone part 220625, making identification easy for owners of those brands.
Measures 4.43 x 1.88 x 1.79 inches -- a precise dimensional match to the original bracket for accurate reinstallation.
This is the left-side bracket only. The right-hand equivalent is Lippert part 1059621, sold separately.
Slide-out mounting brackets are side-specific -- left and right are not interchangeable. When determining which side you need, face the slide-out room from inside the RV looking toward the exterior wall. The left-hand bracket (this part, 1059611) mounts on your left. The right-hand bracket (1059621) mounts on your right.
This bracket is intended for Lippert electric slide-out systems built on the following tube-frame configurations:
These systems are found across a wide range of travel trailers, fifth wheels, and toy haulers built by Jayco, Keystone, Forest River, and other manufacturers who sourced Lippert slide-out hardware. Always verify the tube size on your existing bracket before ordering.
Replacing a slide-out mounting bracket typically requires retracting the slide-out room fully, supporting the room during bracket removal, and transferring any hardware from the old bracket to the new one. Torque all fasteners to the spec listed on your slide-out system's service label or Lippert documentation for that model year.