When your Lippert electric steps stop responding -- or cycle erratically -- the control module is often the first component to fail. This direct-replacement module restores full operation on A/B/C linkage IMGL step motor systems without rewiring or cutting into existing harnesses. Designed and warranted by Lippert, it drops into place where the original unit was, using the included wiring harness for a clean, factory-style repair.
Lippert electric steps are found on a wide range of Class A, Class C, fifth wheels, and travel trailers. The control module is the brain of the system -- it interprets door-switch signals, drives the step motor, and monitors for stall conditions that could damage the motor or mechanism. Part number 13-2434 (also referenced as Lippert part 776367) is the correct replacement module for systems using A, B, or C linkage IMGL-style step motors.
If your steps are not extending or retracting when the door opens or closes, are moving sluggishly, or the motor runs but the steps do not respond to door signals, this module is a practical first diagnostic replacement. Installation is straightforward for any owner comfortable with basic 12V wiring.
Designed specifically for A/B/C linkage IMGL step motors found on a wide range of Lippert step assemblies across multiple RV brands and model years.
Comes with the mating wiring harness so you can connect directly to your existing step and door-switch wiring without splicing or fabricating connectors.
10-amp stall current rating protects the step motor from overload conditions caused by obstructions, ice buildup, or mechanical binding.
Backed by Lippert's limited 1-year manufacturer warranty. Lippert is a major OEM supplier, so warranty support and parts availability are reliable.
This module is compatible with Lippert electric step assemblies using A, B, or C linkage IMGL step motors. Lippert-branded steps are installed OEM on RVs from manufacturers including Forest River, Coachmen, Keystone, Heartland, and many others. If your step assembly has a Lippert label or was supplied by Lippert Components (formerly Kwikee in the step product line), verify the motor type before ordering.
Replacement is typically a disconnect-and-reconnect procedure. The wiring harness plugs into the step motor lead and the door-switch circuit. The module mounts to the step frame using the existing bracket and fasteners. No programming or calibration is required -- the module is ready to operate once connected to a 12V supply and a functioning IMGL step motor.
This item ships via ground service only. Priority or expedited air shipping is not available for this product.