Get your slide-out room moving again with this direct-replacement gear pack from Lippert Components. Part 324869 is engineered specifically for LCI above-floor and through-frame slide-out systems using 2.5 x 2.5 inch rack tubing. It ships fully assembled and ready to bolt in, so you can skip the bench work and get back on the road.
Lippert slide-out gear packs take a beating over thousands of cycles. Worn, stripped, or cracked gears cause slow movement, grinding noise, or a slide-out that refuses to retract -- all problems that put your trip on hold. The 324869 restores factory-spec engagement between the motor gearbox and the rack tube so your slide operates smoothly and reliably.
This is a standard gear pack assembly -- not an oversized or heavy-duty variant. It is matched to the standard 2.5 x 2.5 inch square rack tubing found on a wide range of LCI above-floor and through-frame slide-out installations. The 15-tooth spur gear provides the correct tooth count and pitch for proper mesh with the rack.
15-tooth spur gear matches the OEM tooth pitch and profile for smooth, rattle-free rack engagement on LCI systems.
Pack ships as a complete, pre-assembled unit. Remove the old gear pack, install the new one -- no pressing or sub-assembly needed.
Designed for 2.5 x 2.5 inch square rack tubing. Verify your tubing size before ordering to ensure correct fitment.
Backed by a limited 1-year manufacturer warranty from Lippert Components for defects in materials and workmanship.
The 324869 gear pack is used on two common LCI rack-and-pinion slide-out configurations:
Both system types use the same gear pack interface when the rack tubing measures 2.5 x 2.5 inches. If your LCI slide uses a different tubing size, a different gear pack part number is required.