When your Power Gear manual leveling touchpad stops responding or your control harness fails, the Lippert 359259 is the direct-replacement kit built to restore full leveling function. Designed specifically for 2000 through 2005 Power Gear manual leveling systems, this kit includes the complete touchpad and power harness so you can get back on solid ground without hunting for individual components.
The Lippert 359259 Manual Leveling Control Kit is a genuine replacement for the original Power Gear control interface found on a wide range of towables and motorhomes produced in the early-to-mid 2000s. Rather than replacing the entire leveling system, this kit targets the most common failure point -- the control panel and harness -- letting you perform a focused, cost-effective repair.
Power Gear leveling systems are known for durability, but touchpad membranes and wiring connectors degrade over time from heat, vibration, and repeated use. Swapping the control kit is a straightforward job most RV owners can complete with basic hand tools.
Engineered to match the original Power Gear manual leveling control interface used on coaches built between 2000 and 2005. No modification required.
Includes both the replacement touchpad control panel and the power harness -- the two components most likely to cause control failures in aging systems.
Uses the standard 8-pin connector that mates directly with the existing Power Gear leveling system wiring harness in compatible coaches.
Runs on the standard 12-volt DC house battery system found in virtually all RVs, no additional power conversion needed.
This kit includes:
This control kit is designed for Power Gear manual leveling systems manufactured from 2000 through 2005. If your coach has a Power Gear automatic leveling system, or a system made outside this date range, verify your existing control panel part number before ordering. The 8-pin connector is the key identifier -- if your current control uses a different pin count, this kit will not be compatible.
How to Confirm Fit: Locate the part number on your existing control panel or check your coach's leveling system documentation. If the control box references Power Gear and falls within the 2000-2005 production window, this kit is the correct replacement. Cross-reference your existing connector to confirm the 8-pin layout.
Replacement is a remove-and-reinstall process. Disconnect the old touchpad from the harness, remove the panel from its mounting location, connect the new harness, and secure the new touchpad in place. No special programming or calibration is required for manual leveling systems -- the new control is operational as soon as it is connected.
Maintenance Tip: While the panel is removed, inspect the connector pins on the leveling system side for corrosion or pushed-back terminals. Clean any corrosion with electrical contact cleaner before installing the new harness to ensure a reliable connection.
Covered by a limited 1-year manufacturer warranty against defects in materials and workmanship. Warranty is fulfilled through Lippert Components.