Restore full leveling control to your RV with this direct-replacement touch panel for Lippert's Ground Control TT, Ground Control 3.0, and Level-Up Hydraulic automatic leveling systems. One-touch auto-level and full jack retraction are right where you need them -- no rewiring, no programming headaches.
A cracked faceplate, failed touch surface, or unresponsive button cluster doesn't mean your entire leveling system needs to be replaced. Lippert's 425306 Quick Level Touch Panel is a purpose-built OEM-style replacement that restores full functionality to three of the most popular automatic leveling systems found on travel trailers and fifth-wheels -- without replacing the hydraulic pump, jacks, or control module.
This panel handles all core leveling functions: one-touch automatic leveling, individual jack extension and retraction, full retract, and real-time status indicator lights so you always know where your jacks are before you move. The plug-and-play wiring harness connector means installation is straightforward for most owners -- disconnect the old panel, connect the new one, and verify operation.
Initiates the full automatic leveling sequence with a single button press. Works with the existing control module logic -- no reconfiguration required.
Single-button full jack retraction before travel. Status lights confirm all jacks are up before you hitch and roll.
LED indicators display system status and individual jack position at a glance -- critical when maneuvering at a tight campsite.
Uses the same wiring harness connector as the original panel. No splicing, no new wiring runs needed for a standard swap.
This touch panel is designed specifically for the following Lippert leveling systems:
If your current panel is cracked, water-damaged, or the touch surface no longer responds reliably, this assembly replaces the entire panel unit. The underlying control module, hydraulic pump, and jacks remain in place.
Lippert leveling control modules are designed to last the life of the RV. In most cases, panel failure is caused by UV degradation, moisture intrusion behind the faceplate, or physical damage -- not module failure. Replacing only the touch panel assembly is the cost-effective fix that avoids pulling the entire control box.
The 425306 panel mounts in the same location as the original using the same fastener pattern. Installation steps for a standard swap:
This product is also cataloged under vendor part number 18-2918. Both numbers reference the same assembly. Use either when searching for compatibility confirmation from Lippert or your RV dealer.
This panel is NOT compatible with all Lippert leveling systems. It is specifically designed for Ground Control TT, Ground Control 3.0, and Level-Up Hydraulic platforms. If you have a Leveleeze, PowerGear, or older HWH-based system, this panel will not plug in or function correctly. Check the label on your existing control module or the original build sheet for your system name before ordering.
Once the new panel is installed, apply a thin bead of self-leveling lap sealant around the panel perimeter if it mounts to an exterior wall. UV exposure and water intrusion at the panel edge are the most common causes of premature touch panel failure. A simple seal extends panel life significantly.