Stop wrestling with a worn or missing tongue jack foot pad. This factory replacement from Lippert gives your travel trailer's tongue jack a stable, level base with four height adjustment positions, so you can dial in the right stance on uneven ground and protect your jack's inner tube from dirt and damage.
The Lippert 405217 is the correct foot pad for the Next Generation (V2) Power Tongue Jack, the LCI Smart Tongue Jack, and the Sidewinder Tongue Jack. If you're replacing a cracked, bent, or lost pad on any of these jacks, this is the part you need -- no drilling, no adapters, just a straight swap secured with the included snap pin.
The 9-inch pad spreads the load across a wider contact area than a bare jack foot, reducing the chance of the jack sinking into soft ground or asphalt at a campsite. The steel construction handles the stresses of daily hitching and unhitching without flexing under load.
Adjustable positioning lets you fine-tune jack height for different terrain and hitch setups without swapping hardware.
Wide base distributes tongue weight over a larger footprint -- helpful on soft ground, gravel, and uneven pads.
Heavy-duty steel with a clear zinc finish resists corrosion during travel and outdoor storage.
Comes with the snap pin needed for installation -- no extra hardware required to complete the job.
This foot pad is the OEM replacement for the following Lippert tongue jack families:
Installation is straightforward for a DIY RV owner: