The MB Sturgis 100284-60 Propane Bulk Adapter Hose gives your small propane appliances -- camp stoves, lanterns, portable heaters -- a direct connection to a bulk propane tank or propane tree. At 60 inches long, it gives you real positioning flexibility without fighting a short tether. The male #600 x female #600 swivel fittings thread up to standard 1-pound bottle ports and most bulk adapters, so no additional adapters are typically required.
Disposable 1-pound propane cylinders are convenient on their face, but they add up fast -- in cost, in waste, and in hassle when they run dry mid-cook. This bulk adapter hose lets you plug directly into a standard 20-pound (or larger) propane tank, giving you far more run time without interruption. It pairs equally well with a propane tree (tee splitter) when you need to run multiple appliances from one tank at a campsite.
The hose itself is a 1/4-inch ID high-pressure rubber hose built to handle propane service. The swivel on the female end prevents the hose from twisting and binding when you reposition an appliance, which matters when you are routing around a picnic table or inside a truck bed camper setup.
Standard Lindal-type fittings thread directly onto most 1-pound bottle appliance inlets and common bulk adapters -- no additional adapter hardware needed in most setups.
High-pressure hose rated to 350 PSI, well above normal LP service pressures, providing a meaningful safety margin for typical camping and RV appliance use.
Five feet of hose gives you comfortable reach from a ground-level bulk tank to a table-top appliance without stressing the fittings or pulling the cylinder over.
Rated from -40 F to 140 F, so it performs reliably in cold-weather camping where stiff hoses and frozen fittings are a real problem.
The #600 fitting (also called a Lindal valve or Type 600 connector) is the industry-standard thread used on virtually all disposable 1-pound propane cylinders and appliances designed for them. The male end of this hose threads into the bulk adapter (or propane tree output port), and the female swivel end threads onto your appliance's fuel inlet -- the same port where the 1-pound bottle would normally screw in.
If your bulk tank uses a POL valve or an Acme (Type 1) outlet, you will need a separate bulk adapter fitting between the tank and this hose. Those adapters are sold separately. The hose itself connects the adapter output to the appliance.