A USA-made, UL/CGA-certified high-pressure propane hose built for connecting your RV or trailer propane supply to high-BTU appliances, generators, fryers, griddles, or any device requiring a full-pressure, unregulated or post-regulator high-pressure propane feed. At 48 inches long, it gives you enough reach to route around cabinets, tanks, or exterior compartments without straining fittings.
Not every propane hose is rated for high-pressure service. The MB Sturgis 06-1380 is specifically designed to handle up to 350 PSI -- well above the working pressure of typical RV propane systems -- making it safe and appropriate for connections on the high-pressure (pre-regulator) side of the system or for appliances that require higher delivery pressure than a standard low-pressure regulated line can provide.
The 3/8" female flare swivel end threads onto a standard 3/8" male flare fitting without twisting the hose body, which prevents kinking and makes installation in tight compartments much easier. The 3/8" MPT (male pipe thread) opposite end connects directly to appliance inlets, tee fittings, or high-pressure regulators with a standard 3/8" female pipe thread port.
Rated for high-pressure propane service, well above typical RV system working pressures for a wide safety margin.
The 3/8" female flare swivel rotates freely so you can tighten connections without twisting or kinking the hose body.
Rated from -40 deg F to 140 deg F, handling cold-weather camping and warm summer use without hardening or cracking.
Meets UL and CGA standards for propane hose assemblies. Manufactured in the United States by MB Sturgis.
Getting the thread types right matters on propane -- a wrong-thread connection will leak. This hose uses two distinct thread standards: