A complete, plug-and-play wiring solution for 12-volt sprayer pumps. This 98-inch harness is built with heavily insulated 16 AWG bonded copper wire, a heavy-duty 30 amp on/off switch, standard 2-pin SAE connectors on each end, and two 30 amp battery clips -- everything needed to power up a sprayer pump without splicing or sourcing parts separately.
Remco designed the 901-004-R harness kit to pair directly with their 2200, 2400, 3200, 3300, and 5500 Series sprayer pumps, as well as any other 12-volt pump or accessory using the standard 2-pin SAE connector. The 98-inch run -- just over 8 feet -- gives you enough reach to route wiring cleanly from a battery bank to a pump mounted in a truck bed, trailer, ATV, or utility skid without extension splices.
The red and black bonded wire construction keeps positive and negative runs together and properly insulated for automotive and outdoor environments. The included 30 amp rated components -- switch and battery clips -- are sized for pumps up to 5.3 GPM, covering the full range of Remco's sprayer pump lineup and most comparable third-party units.
Heavily insulated red and black bonded pair rated to carry 30 amps continuously without voltage drop issues across the 98-inch run.
Heavy-duty switch handles the full current draw of 12V sprayer pumps from 1.0 to 5.3 GPM. No relay or additional switch required.
One connector on each end of the 98-inch harness. The 2-pin SAE format is the industry standard for Remco pumps and most 12-volt sprayer pump brands.
Included battery clips provide a direct and secure connection to any 12-volt battery. No permanent wiring required for temporary or seasonal setups.
This harness is rated and designed for 12-volt DC sprayer pumps across the following flow ranges: