Stop wind from destroying your RV awning. The Valterra A10252 Awning Saver Clamps grip the side arms of your RV awning to prevent flapping, stress tears, and fabric damage -- no tools, no ladders required. Two clamps and all hardware included.
Even a moderate gust can cause an unrestrained RV awning to flap repeatedly, stressing the fabric and hardware until you end up with a rip, a bent arm, or worse. The Valterra A10252 Awning Saver Clamp is a straightforward, low-profile solution: clamp it to the awning side arm, tighten the wingnut by hand, and the awning stays put.
Made from high-strength, rust- and corrosion-resistant plastic, these clamps won't scratch or abrade the awning fabric. The compact profile means they store easily in a bin, a storage bay, or even a jacket pocket when not in use. No tools, no ladder, no replacement parts -- just grab them, attach, and go.
Hand-tighten the included wingnuts to secure the clamp to the side arm. Remove just as quickly when you're ready to retract the awning.
Smooth plastic contact surfaces grip the arm -- not the fabric -- so there is no abrasion, staining, or material damage to your awning.
All-plastic construction resists moisture, road salt, and UV exposure. No metal components to corrode or seize after a season outdoors.
At 10 in. x 5 in. each, these clamps nest flat and tuck into any storage space -- a small bin, a hitch compartment, or a utility drawer.
Any RV owner who leaves the awning extended while camping in variable conditions -- afternoon thunderstorms, coastal breezes, open desert wind corridors -- should have a set of awning saver clamps on hand. They are especially useful for:
No special skills needed. Slide the clamp over the side arm of the awning, position it so it bridges and stabilizes the arm, then hand-tighten the wingnut until snug. Both clamps can be installed in under two minutes without climbing a ladder or reaching above shoulder height on most RV setups.