When your gooseneck setup needs to pull double duty -- or you just want a clean, chrome-finished stinger that handles two different trailer ball sizes -- the B&W TS10037C delivers. Designed specifically for the B&W Turnoverball gooseneck hitch system, this 8-inch shank stinger drops into your existing receiver and gives you two factory-mounted balls ready to go, no swapping hardware mid-trip.
The B&W TS10037C is built for owners who tow more than one trailer and don't want to deal with switching ball mounts at the tailgate. The dual ball configuration gives you quick access to both common industry ball diameters on a single polished chrome shank -- ideal for pulling a fifth-wheel with a gooseneck coupler one weekend and a bumper-pull or conventional trailer the next.
This stinger is a direct accessory for B&W's Turnoverball gooseneck hitch platform, one of the most trusted names in heavy-duty truck towing. The 8-inch shank length accommodates truck beds where the hitch ball sits deep enough to require extended reach, keeping couplers at the correct geometry and preventing excessive tongue-angle stress on your trailer.
Two industry-standard ball sizes pre-mounted on a single shank -- no tools, no swapping, no fumbling at the tailgate before a haul.
Triple-chrome plating resists corrosion, road salt, and UV exposure, keeping the stinger looking clean through years of truck-bed life.
Extended 8-inch shank reaches the sweet spot in full-size truck beds, delivering proper coupler height geometry for gooseneck trailers.
Engineered to work with B&W's Turnoverball gooseneck hitch receiver. Drops in and locks with the same familiar interface you already trust.
The Turnoverball is B&W's flagship gooseneck hitch platform, installed in the bed of full-size pickup trucks (Ford F-Series, GM Sierra/Silverado, Ram 1500/2500/3500, and others). When the ball is not in use, the Turnoverball flips over flush with the truck bed -- keeping the bed usable for cargo. The TS10037C stinger is an accessory ball mount that inserts into the Turnoverball receiver to present the towing ball(s) at the correct height for gooseneck trailer couplers.
This isn't decorative chrome. The TS10037C's finish is applied to a heavy steel shank built to handle the shock loads and vibration of gooseneck towing on rough roads. Chrome also makes it significantly easier to clean -- wash off the road grime and it stays presentable without the rusting and pitting you see on bare steel alternatives.
The TS10037C is designed for use with B&W Turnoverball gooseneck hitch systems. It is NOT a universal ball mount for standard 2-inch or 2.5-inch square receivers -- it is specific to the B&W Turnoverball receiver interface. Confirm you have an installed B&W Turnoverball hitch in your truck bed before ordering this stinger.