The Aqua View Bronze RV SHOWERMISER Unit is a water saving system that attaches to the showerhead in your RV, boat or anything with a shower.
- It redirects cold water that normally goes down the drain back into the fresh water tank. In under 4-seconds, the SHOWERMI$ER shows when the hot water has arrived by using its unique color-changing technology.
- A shower is then ready to be taken and not a drop of cold clean water is wasted.
- Just flip the lever back to the showerhead and you're ready to go.
- Conserves fresh water.
- Saves gray water tank capacity.
- Extended Stay” Technology gives you the ability to stay out in your RV longer by conserving both your fresh and gray water capacities up to 40%.
- Saves time, money and helps the environment.
- Easy to clean, just use water and a soft cloth.
- Tube changes color at 91 degrees Fahrenheit.
- 100% brass construction with a less than 2% lead content.
- Allows you to fill the fresh water tank from inside your RV instead of outside, follow these steps:
- Do not disconnect your outside water source.
- Check your control panel to see how much fresh water you have in your water tank.
- Turn the SHOWERMI$ER lever/valve to bypass the shower head.
- Turn the cold water shower valve to full pressure.
- Keep an eye on the water control panel.
- When it shows full, turn OFF the shower valve.
- Perfect for use on an RV shower, saving water and money.
- Includes: (1) SHOWERMI$ER Unit, (1) Bronze Diverter Valve, (1) custom-threaded through wall pipe and (1) lock nut & washer to secure unit tightly against the shower wall.
- Limited 1-year manufacturer warranty.
Important Note: Must have a return line ran from shower to non-pressurized side of water pump or a freshwater tank for this to work. (Please refer to the live installation video under the instructions tab above).Aqua View Bronze RV SHOWERMI$ER Unit
HOW TO INSTALL: SHOWERMISER connects anywhere on the non-pressurized side of the fresh water system, (for example, the fresh water tank or the input side of the water pump). Simply remove the shower head and attach this unit. Line up and mark where the return line will be. Drill a single hole in your RV shower wall through to the inside wall where the other plumbing is maintained. Using the provided lock washer, tighten the SHOWERMISER snugly against the wall. Using a return line with a 1/2″ female pipe thread fitting, attach the return line to the Aqua View unit. Lastly, connect the other side of the return line to anywhere it is convenient on the non-pressurized side of the fresh water system.
|