Give your rig a fresh look and solid protection with a factory-quality replacement awning fabric from Carefree of Colorado. The JU198A00 combines the main canopy and valance into a single uniform piece, delivering a clean, classic profile when fully extended -- and a White Weatherguard panel that shields the rolled fabric from UV, scrapes, and road grime on the move.
When your existing awning fabric is faded, torn, or delaminating, a full fabric replacement is almost always more cost-effective than buying a new awning assembly. The JU198A00 is engineered to reinstall using the same polyrod-and-slot system already built into your roller tube, so you are not retrofitting anything -- just swapping like for like.
The double-sided Sierra Brown Dune Stripe pattern looks the same from inside or outside the awning, so your view from the patio is as sharp as the curb appeal from the campsite. The smaller stripe scale is intentional -- it complements the proportions of a standard RV side wall without competing with it.
Valance and main canopy are cut and hemmed as one continuous piece -- no seam line, no color mismatch between sections.
Protects rolled fabric from UV exposure, scrapes against the RV sidewall, and moisture when the awning is stored during travel.
Two polyrods seat into two separate slots in the roller tube for a secure, rattle-free hold that matches OEM installation standards.
Sierra Brown Dune Stripe is visible from both sides of the fabric -- consistent appearance whether you are relaxing under it or approaching your rig from the outside.
Awning fabric is intentionally cut shorter than the full awning width. This fabric measures 18 ft 2 in and is designed for 19 ft awning assemblies. The fabric runs approximately 5 inches short on each side (10 inches total) relative to the awning arm spread -- this is normal and by design, not a defect.
This fabric uses a standard polyrod attachment system and standard poly cord sizing, which makes it compatible with a wide range of roller-style awning assemblies beyond just Carefree-branded units. Confirmed compatible brands include:
If your existing awning uses a dual-polyrod roller tube with standard poly cord slots, this fabric will fit. If your awning uses a snap-style or screw-on retention system, verify compatibility before ordering.
The fabric is woven and coated vinyl at 13.5 oz per square yard -- a mid-to-heavy weight that resists stretching, holds color under UV exposure, and sheds water efficiently. The single-hemmed perimeter uses traditional fabric thread rather than welded or glued seams, keeping the edge flexible and resistant to cracking in cold weather.
Replacement follows the standard Carefree fabric swap procedure: unroll the existing fabric, slide out the old polyrods, feed the new fabric onto the roller tube using the included spline tool to seat each polyrod into its slot, then reattach the lead rail cord. Most installers complete the job in under two hours with basic hand tools. The included instructions cover the process step by step.