Home > Appliances >

Dinosaur Electronics N991 Norcold Refrigerator Power Supply Circuit Board -- 900/9100 and Early 1200 Series

Dinosaur Electronics N991 replacement power supply circuit board for Norcold 900 9100 and early 1200 series RV refrigerators, part 39-0499
Dinosaur Electric Circuit Board
 
List Price: $476.19
: $291.49
You save $184.70!
Part Number: 39-0499
Manufacturer: Dinosaur Electronics

Quantity in Stock :27

Free Shipping
Availability: In Stock
Qty:

 
Dinosaur Electronics USA Made 3-Year Warranty Dinosaur Electronics N991 -- Norcold Refrigerator Power Supply Circuit Board

Stop chasing down an intermittent or dead Norcold fridge. The Dinosaur Electronics N991 is a direct-fit, USA-made replacement power supply circuit board engineered for Norcold 900, 9100, and early 1200 series absorption refrigerators. It restores full AC, DC, and LP gas operation and backs it all with a 3-year limited warranty -- longer coverage than most OEM boards.

The Right Fix for an Aging Norcold Power Board

Norcold 900 and 9100 series refrigerators are workhorses found in thousands of RVs, but their original power supply boards are known failure points. Symptoms include the fridge refusing to switch between power modes, failing to light on LP, or losing DC operation entirely. The N991 addresses all of those failure modes with a purpose-built replacement that matches the OEM connector layout and mounting footprint.

Dinosaur Electronics has been producing aftermarket RV refrigerator boards in the USA since the 1990s. The N991 is one of their most-installed boards, covering six Norcold OEM part numbers across two major refrigerator families. It is a direct plug-and-play replacement -- no rewiring, no adapters required for supported models.

AC, DC, and Gas Operation

Supports full 2-way (AC/DC) and 3-way (AC/DC/LP gas) absorption refrigerator operation. Handles automatic or manual mode switching.

Replaces 6 OEM Part Numbers

Direct replacement for Norcold 618198, 618224, 618574, 618575, 618828, and 619378 -- covering multiple production runs of the 900/9100 and early 1200 series.

USA Made

Designed and manufactured domestically by Dinosaur Electronics. Components are selected for RV duty -- vibration, heat cycling, and extended storage periods.

3-Year Limited Warranty

Backed by Dinosaur Electronics' 3-year limited warranty -- significantly longer than typical OEM replacement boards, which often carry only a 1-year coverage period.

What This Board Replaces

The N991 is the correct board when your Norcold unit carries one of the following OEM part numbers printed on the existing board or listed in your refrigerator's service manual:

  • 618198
  • 618224
  • 618574
  • 618575
  • 618828
  • 619378

If your board number is not on this list, verify your refrigerator model number against Norcold's service documentation or contact Dinosaur Electronics directly before ordering. Installing an incorrect control board can damage the refrigerator's heating element circuit.

DIY-Friendly Installation
The N991 uses the same connector positions and mounting points as the OEM boards it replaces. Most experienced RV owners complete the swap in under 30 minutes with basic hand tools. No soldering or custom wiring is required for supported models.

Common Failure Symptoms This Board Addresses

  • Refrigerator will not operate on LP gas (no ignition or ignition lockout)
  • No DC operation -- fridge only runs on shore power AC
  • Unit powers on but does not cool on any mode
  • Error codes or check light triggered immediately on startup
  • Intermittent operation -- fridge works sometimes but drops out
  • Board shows visible burn marks, swollen capacitors, or relay damage
Absorption Refrigerator Note: The N991 controls the power switching and ignition logic for the refrigerator. It does not replace the thermistor, heating element, or gas valve -- those are separate components. If the new board does not resolve your cooling issue, the heating element or burner assembly should be inspected next.
Installation Tips
  • Disconnect shore power and battery before removing the old board.
  • Turn off the LP gas supply at the tank before any work near the refrigerator compartment.
  • Photograph existing wiring connections before unplugging the old board.
  • Inspect all wiring harness connectors for corrosion or heat damage before installing the new board.
  • After installation, test all three operating modes (AC, DC, LP) before closing the exterior access panel.
Verify Compatibility Before Installing: Confirm your existing board part number matches one of the six OEM numbers listed above. The 900/9100 and early 1200 series share similar cabinet designs but use different board revisions. Installing the wrong board may result in improper operation or component damage not covered under warranty.

Part Identification

ManufacturerDinosaur Electronics
Model / Part NumberN991
SKU39-0499
UPC816689023106
Country of ManufactureUSA

Compatibility

Fits Refrigerator BrandNorcold
Compatible Series900 Series, 9100 Series, Early 1200 Series
OEM Part Replaced618198, 618224, 618574, 618575, 618828, 619378
Operation ModesAC, DC, LP Gas (2-way and 3-way)

Physical Specifications

Box Dimensions7.5 x 10.75 x 3 inches

Warranty and Support

Warranty3-Year Limited Warranty
Manufacturer SupportDinosaur Electronics (USA)

What Is Included

IncludedN991 power supply circuit board (1)
Not IncludedMounting hardware, wiring harness, thermistor, heating element, gas valve
Important Information
  • Confirm your existing board carries one of these OEM part numbers before ordering: 618198, 618224, 618574, 618575, 618828, or 619378. Installing an incompatible board may cause damage not covered under warranty.
  • Disconnect all power sources -- shore power, battery, and LP gas -- before removing the old board or handling wiring.
  • This board controls power switching and ignition logic only. It does not replace heating elements, gas valves, thermistors, or burner assemblies.
  • Inspect all wiring harness connectors and terminals for corrosion or heat damage before installing. A damaged harness will cause the new board to fail prematurely.
  • Test operation on all three modes (AC, DC, and LP gas) after installation before returning the unit to service.
⚠️ WARNING: This product can expose you to one or more chemicals known to cause cancer and/or birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov


Browse for more RV Accessories in the same category as this item:

Appliances
Appliances > Appliance Circuit Boards


$711.99
$29.99
$251.99
$29.30