The Equal-i-zer 14-3327 Snap L-Pin is a direct replacement for the original L-pin-and-cotter-clip assembly used on Equal-i-zer weight distribution hitches. One piece, one step -- snap it in to lock the spring arm to the L-bracket, snap it out to release. No separate clip to drop in the dark, no fumbling with cotter pins at a crowded campsite.
If you have ever knelt in gravel trying to thread a cotter pin through an L-pin hole while your tow vehicle idles, you understand why Equal-i-zer redesigned this part. The Snap L-Pin uses an integrated snap-down/click mechanism that locks the pin in place automatically when fully seated. Releasing it requires the same single motion in reverse -- no tools, no separate clip, no loose hardware to lose.
Beyond convenience, the new design holds the pin slightly elevated above the weight distribution arm rather than bearing directly on it. That small clearance is what eliminates the metallic ticking and rattling that some owners experience with the original pin design during slow tight turns and normal road maneuvering.
Integrated snap clip replaces the two-piece L-pin plus separate cotter pin and clip. Engages and releases in a single step.
Pin rides slightly above the weight distribution arm, reducing metal-on-metal contact during maneuvering and tight turns.
Designed to replace the original Equal-i-zer L-pin, L-pin clip, socket pin, and socket pin clip -- all in one assembly.
Meets the same safety and retention standards as the original L-pin hardware. No compromise in arm security during towing.
On standard Equal-i-zer hitches, each spring arm attaches to its L-bracket via an L-shaped pin retained by a cotter pin and a separate clip. That four-piece arrangement works reliably but creates unnecessary steps at hookup and teardown. The 14-3327 Snap L-Pin consolidates the L-pin, L-pin clip, socket pin, and socket pin clip into a single captive assembly. Install once -- after that, each hookup is a one-handed snap-in.
This listing is for one (1) Snap L-Pin. Most Equal-i-zer hitches use two spring arms and therefore require two pins. Order two if you are replacing hardware on both sides.
The 14-3327 Snap L-Pin is designed for use with Equal-i-zer 4-point sway control weight distribution hitches across the standard product line. It replaces the factory L-pin hardware on the spring arm L-bracket connection point. Verify the L-bracket pin hole diameter and arm style on your specific hitch head matches the standard Equal-i-zer configuration before ordering.
The Snap L-Pin is a convenience and noise-reduction upgrade, not a load-capacity upgrade. It does not change the rated tongue weight or gross trailer weight capacity of your hitch. Always set up your weight distribution system per Equal-i-zer's torque and tension specifications.
No tools required for installation or daily use. When replacing existing hardware, remove the old L-pin, cotter pin, and clip from the L-bracket. Insert the Snap L-Pin through the bracket and arm in the same orientation as the original pin. Press down until the snap mechanism clicks -- the pin is now locked. To remove, depress the snap tab and withdraw the pin.
Periodically inspect the snap mechanism for wear, deformation, or corrosion, especially if towing in wet or salty environments. A light coating of grease on the pin shank reduces wear and keeps the snap action positive. Replace the pin if the snap no longer clicks firmly into the locked position.
This is a single-pin listing. A standard Equal-i-zer hitch uses one pin per spring arm. Most two-arm hitches require two pins total for a complete hardware replacement. Check how many pins your configuration needs before ordering.