A reliable OEM-style replacement LP supply hose designed for RV propane distribution systems. At 6 feet long with industry-standard 3/8" female pipe and swivel SAE flare fittings on each end, this hose routes easily between your LP regulator, appliance shutoffs, and distribution manifolds -- without hacks or adapters in most common RV setups.
This JR Products supply hose is built to OEM specifications and is a direct fit for many factory LP plumbing configurations found in travel trailers, fifth wheels, and motorhomes. The 72" length gives you enough slack to route around cabinetry and chassis framing without stressing the fittings or creating sharp bends that can crack over time.
The 1/4" inner diameter is the standard size used throughout most residential-style RV LP distribution systems, feeding appliances such as ranges, furnaces, water heaters, and refrigerators. Both end fittings are pre-installed -- no field assembly, no ferrule crimping required.
Matches the OEM LP supply hose diameter used in most RV propane distribution systems from the regulator to individual appliances.
3/8" female pipe (FPT) on one end and 3/8" female swivel SAE flare on the other -- covers the most common RV LP connection pairing.
Meets Underwriters Laboratories and Canadian Standards Association requirements for LP gas hose assemblies, as required by most RV manufacturers and campground park models.
72 inches of hose provides generous routing flexibility inside RV cabinetry and underbelly LP compartments without requiring extension couplings.
Getting the right hose means matching both ends to your existing connections. This hose ships with:
The swivel end rotates freely for easy alignment during installation without twisting the hose body. No thread tape is needed on the SAE flare end; use approved LP-rated thread sealant on the FPT end only.
This hose is commonly used in the following locations inside an RV LP system:
Installation is straightforward for anyone familiar with RV LP plumbing. No special crimping tools are required -- both fittings are pre-assembled at the factory.