A direct OEM-style replacement pigtail hose for RV propane systems. This 24-inch hose connects a QCC1 (Type 1) propane tank valve to an appliance or regulator with a 1/4" male inverted flare inlet -- the standard connection used on most RV furnaces, water heaters, ranges, and secondary regulators. UL and CSA listed for safe, code-compliant installation.
JR Products is one of the most widely trusted names in RV propane hardware, and the 07-30755 pigtail hose is a staple in the replacement parts aisle for good reason. Whether you are replacing a cracked or kinked hose on a travel trailer, fifth wheel, or Class A/B/C motorhome, or building a custom dual-cylinder propane manifold setup, this hose delivers a secure, leak-resistant connection between your QCC1-equipped propane cylinder and the downstream appliance side of your system.
The rubber construction is rated for LP gas service, and the inverted flare end threads directly onto 1/4" flare fittings without adapters in most applications. At 24 inches, it provides enough working length for typical pigtail-to-regulator or pigtail-to-appliance runs without excess slack that could droop near heat sources.
Threaded QCC1 (Type 1) end mates securely to standard U.S. propane cylinder valves -- no adapters needed for most RV and camping cylinders.
Opposite end uses a 1/4" male inverted flare fitting, the standard inlet size for most RV regulators, furnaces, ranges, and water heaters.
Independently tested and certified for LP gas service. Meets safety standards required by most RV manufacturers and service technicians.
Built to original equipment specifications. Direct drop-in for worn or damaged pigtail hoses on dual-cylinder auto-changeover or single-cylinder propane setups.
A pigtail hose is the flexible connector between a propane cylinder valve and the first fixed component in your propane system -- typically a regulator or a manifold. QCC1 (Quick-Closing Coupling, Type 1) is the standardized large-thread left-hand fitting used on virtually all U.S. propane cylinders 4 lbs and larger, including the standard 20 lb and 30 lb tanks used on most towable and motorized RVs.
The 1/4" male inverted flare on the other end is the most common downstream thread found on single-stage and two-stage RV regulators, as well as many appliance inlet connections. If your regulator or appliance has a 1/4" female flare port, this hose connects directly with no additional fittings.