A direct-replacement OEM-style propane pigtail built for RV dual-cylinder manifold systems and single-tank setups. The 06-0132 pairs a tool-free QCC1 inlet with a 1/4" male inverted flare outlet on a 12-inch flexible rubber hose -- the standard short-run connector between a propane tank valve and a regulator or changeover valve.
Propane pigtails take daily flexing, UV exposure, and temperature swings. When an original hose cracks, stiffens, or shows surface checking, it needs to come out -- not get taped. The JR Products 06-0132 is sized and threaded to drop right into the same position as the factory hose on most RV changeover manifold systems, keeping your connection leak-free and code-compliant.
The QCC1 (Type 1) connection threads onto standard OPD (Overfill Protection Device) valves found on all DOT propane cylinders sold in North America since 1998. No tools needed at the tank end -- hand-tighten the QCC1 collar. The 1/4" male inverted flare outlet connects to your regulator, automatic changeover valve, or manifold inlet with a standard propane wrench.
Type 1 QCC1 collar fits all standard OPD propane cylinders. Hand-tighten only -- no wrench needed at the tank end.
Standard 1/4" male inverted flare (MIF) threads into regulators, changeover valves, and manifold inlets without adapters.
Listed to UL and CSA standards for LP gas service. Meets campground, state park, and RV park requirements where code compliance is checked.
1/4" ID rubber hose body provides enough flex to route around tank brackets without stress on fittings. Purpose-built for short-run manifold connections.
The 06-0132 is the standard short pigtail used in RV propane systems in several configurations:
Installation is straightforward but propane fittings require attention to detail: