A direct OEM-spec replacement bushing from Lippert Components, engineered for pivot points, slide-out mechanisms, and chassis linkage applications where precise bore tolerance and wear resistance matter. Bronze construction provides self-lubricating properties and long service life even under repetitive load cycling.
Bushings are small parts that take on serious work. In Lippert slide-out systems, they sit at pivot and guide points where metal-on-metal contact would quickly cause wear, slop, and eventual failure. This 116551 bronze bushing maintains tight clearances between a 0.63 in. shaft and a 0.75 in. bore, keeping motion smooth and predictable over thousands of cycles.
Bronze is the preferred material for this class of RV bushing -- it is harder than nylon, handles moderate side loads, and has inherent lubricity that reduces maintenance requirements. When your slide-out starts to feel sloppy, bind at certain points, or shows visible wear at a pivot, replacing the bushing is often the correct first step before more expensive component replacement.
Self-lubricating bronze alloy resists wear under repetitive cycling and handles the lateral loads common in slide-out pivot applications.
0.75 in. O.D. and 0.63 in. I.D. are held to close tolerances, ensuring proper shaft-to-housing fit without slop or binding.
Lippert part number 116551 ensures you are ordering the correct factory-spec component, not an approximate aftermarket substitute.
Used across multiple Lippert slide-out room systems and chassis linkage assemblies found on a wide range of RV brands and floor plans.
Slide-out bushings wear gradually. Watch for these signs that the bushing at a pivot point needs replacement:
Bushing replacement is a straightforward job for anyone comfortable with basic mechanical work on their RV. The bushing is pressed or tapped into its housing bore. Key points: