A straightforward, precision-fit replacement washer for Lippert trailer axle spindles. If you are servicing a 2,000 to 3,500 lb capacity axle and need to replace worn or missing spindle hardware, this is the correct OEM-specification washer to have on hand before the job starts.
Spindle washers are easy to overlook until you have one that is pitted, corroded, or deformed from heat and load cycles. The Lippert 119214 replaces that washer with an OEM-spec part engineered to seat correctly against the hub bearing and spindle nut on Lippert-built trailer axles rated from 2,000 to 3,500 lbs capacity.
At just 0.05 lbs, this is a lightweight but load-critical component. It distributes clamping force from the spindle nut evenly across the bearing face, helping maintain proper bearing preload and preventing the nut from digging into softer bearing surfaces. Do not skip or substitute this washer during a wheel bearing repack or axle spindle rebuild.
Designed to Lippert's own dimensions -- 1" bore, 1.68" OD -- so it seats correctly without modification on compatible Lippert axle spindles.
Rated for use on 2,000 lb through 3,500 lb capacity trailer axles, covering the most common range of RV travel trailers and utility trailers.
Cross-references Lippert vendor part 62-0845. Order with confidence knowing this is the correct OEM replacement part number.
At 0.05 lbs, this washer adds virtually nothing to your parts kit but is essential to a correctly assembled spindle and hub.
Spindle washers should be inspected any time you pull a hub for bearing service. Replace the washer if you see any of the following:
This washer covers the most common RV trailer and light utility trailer axle ratings. If your trailer has a Lippert or Dexter-style axle in the 2,000 to 3,500 lb range, this washer is the correct spec. For axles above 3,500 lbs -- such as 5,200 lb or 6,000 lb capacity units -- verify the correct washer part number for your specific axle tag before ordering.
This washer is designed for Lippert axle assemblies and is compatible with spindles using a 1" shaft diameter and requiring a washer with a 1.68" outer diameter. It is commonly used on: