Genuine Lippert trailer axle wheel lug stud for compatible 5,200-, 6,000-, and 7,000-lb trailer hub assemblies. Features 9/16"-18 threads, a 2.31" stud length, and a 0.617" knurl.
The Lippert 132624 wheel lug stud is a replacement drive-in stud for compatible trailer axle hub assemblies. It is used to help secure the trailer wheel to the hub and is designed for hubs that use a 9/16"-18 wheel stud with a 0.617" knurl.
This stud is used on compatible 5,200-, 6,000-, and 7,000-lb axle hub applications. Match the original stud thread size, length, knurl diameter, hub bore, and wheel hardware before ordering.
Fine thread wheel stud for compatible trailer hub assemblies
Replaces a drive-in wheel stud in supported trailer axle hubs
Knurled shoulder helps secure the stud in the hub
Steel construction with corrosion-resistant zinc plating
Lippert 132624 is a trailer wheel lug stud. It is not a suspension bolt, shackle bolt, wet bolt, shoulder bolt, leaf spring bolt, or leveling / slide-out hardware.
Match by thread size, stud length, knurl diameter, hub application, and axle rating. Wheel studs must be properly seated in the hub and paired with the correct matching lug nuts.
1. Confirm Fit: Match the original stud thread size, length, knurl diameter, and hub application. 2. Remove Damaged Stud: Remove the wheel and press or drive out the damaged stud using proper hub service procedures. 3. Install New Stud: Seat the replacement stud squarely in the hub without damaging the knurl or hub bore. 4. Reinstall Wheel: Use the correct matching 9/16"-18 lug nuts and torque to the trailer manufacturer’s specification. 5. Recheck Torque: Recheck lug nut torque after initial travel and during normal trailer maintenance. Wheel stud replacement should be performed by a qualified technician if hub fitment, stud seating, or wheel torque procedures are uncertain.
Lippert 132624 trailer axle wheel lug stud
Lippert Customer Support: Phone: 432-LIPPERT (432-547-7378) Website: lippert.com For fitment help, confirm the original wheel stud part number, thread size, stud length, knurl diameter, hub assembly, and axle capacity before ordering.