Complete Lippert 10" brake hub kit for compatible 3,500-lb trailer axles with 5 on 4-1/2" bolt pattern and 1/2" wheel studs. Includes pre-greased installed bearings and wheel-end hardware for one hub replacement.
The Lippert 2024013264 / K-122460 brake hub complete kit is designed for compatible 3,500-lb trailer axle applications with a 5 on 4-1/2" bolt pattern and 1/2" wheel studs. The hub assembly comes with the bearing kit installed and pre-greased to help simplify wheel-end replacement.
This complete kit includes the brake hub assembly, dust cap with plug, cotter pin, castle spindle nut, round spindle washer, and five 60° cone trailer lug nuts. It is compatible with electric or hydraulic drum brake applications when the hub, axle rating, brake size, bolt pattern, bearings, and stud size match.
Designed for compatible 3,500-lb trailer axle hub applications
Bearing kit comes installed and pre-greased for easier service
Fits compatible hubs using a 5-lug, 4-1/2" bolt circle
Includes pre-installed 1/2" zinc-plated wheel studs
This part is a 10" trailer brake hub complete kit. It is not a complete axle beam, hydraulic brake actuator, surge coupler, master cylinder, brake backing plate, or full brake assembly. Before ordering, confirm axle rating, brake size, bolt pattern, wheel size, stud size, bearing set, seal size, and brake type.
This hub kit is made for compatible 3,500-lb axle applications with a 10" brake size, 5 on 4-1/2" bolt pattern, and 1/2" wheel studs. Axle capacity alone is not enough to confirm fit. Always compare the existing hub, drum size, bearing numbers, grease seal size, bolt pattern, stud size, and wheel size before ordering.
1. Confirm Fit: Match the axle rating, brake size, bolt pattern, wheel size, stud size, bearing set, seal size, and brake type before installation. 2. Remove Old Hub: Safely lift and support the trailer, then remove the wheel, dust cap, spindle hardware, and existing hub assembly. 3. Inspect Components: Check the spindle, brake shoes, magnet or hydraulic brake components, wiring or hydraulic lines, and mounting hardware for wear or damage. 4. Install New Hub: Install the pre-greased hub assembly with the included spindle washer, castle nut, cotter pin, dust cap, and lug nuts according to axle manufacturer service procedures. 5. Test Before Towing: Verify bearing preload, hub rotation, brake operation, wheel installation, and lug nut torque before towing. Trailer hub and brake service should be performed by a qualified technician if fitment, bearing preload, brake adjustment, or torque procedure is uncertain.
• Brake hub assembly with installed, pre-greased bearings • Dust cap with plug • 1.75" cotter pin • 1" 6-slot castle spindle nut • Round spindle washer with 1.03" ID and 1.68" OD • 60° cone trailer lug nuts (5)
Lippert Customer Support: Phone: 432-LIPPERT (432-547-7378) Website: lippert.com For fitment help, compare the original hub, brake size, bolt pattern, stud size, bearing set, seal size, axle capacity, and wheel size before ordering.