Give your patio awning a fresh start. This Lippert Solera replacement fabric is purpose-built to fit 11 ft. awnings from Solera, Dometic, and Carefree -- no hacking, no adapter kits. The 13.5-oz vinyl construction holds up through seasons of sun, rain, and temperature swings, while heat-welded seams keep the critical stress points tight and leak-resistant. Made to order in Blue Fade with a clean white underside.
Worn, faded, or torn awning fabric doesn't just look bad -- it compromises the entire purpose of your patio setup. The Lippert V000334351 is engineered as a direct replacement for the fabric panel on 11 ft. awnings, cutting your measurement to 10'1" wide to account for the standard 11-inch offset between fabric width and awning assembly width. The 8 ft. projection gives you full-depth shade coverage from the rolled edge to the drip rail.
Compatible with Solera, Dometic, and Carefree awning assemblies, this fabric slides into existing roller hardware without modification. A poly cord runs the full length and is pre-installed for an optional light track, so you can add LED rope lighting later without re-threading. The roller assembly is not included -- you reuse your existing hardware.
Heavy-duty vinyl fabric weight provides durability and resistance to tearing, sagging, and UV degradation over multiple seasons of use.
Seams are thermally bonded rather than stitched, eliminating needle holes where water can wick through. Critical stress points stay leak-resistant under load.
Vinyl formulation stays flexible and won't crack or split in cold-weather storage or early-season deployments in freezing conditions.
Optional light track cord is already threaded along the underside hem. Add LED rope lighting any time without disassembling the awning.
This is the single most common source of confusion when ordering replacement awning fabric. The fabric width -- 10'1" -- is intentionally about 11 inches shorter than the nominal awning assembly width of 11 ft. This offset is standard across Solera, Dometic, and Carefree assemblies and accounts for the end caps, roller hardware, and mounting brackets on each side. If you measure your current fabric (not the arm span), 10'1" is the correct match for an 11 ft. awning.
Lippert designed this fabric to cross-fit the three most common manual and electric patio awning platforms found on travel trailers, fifth wheels, and Class A/C motorhomes. If your rig has a Solera awning (the OEM brand on many Lippert-equipped trailers), this is the direct OEM-sourced replacement. It also fits equivalent Dometic and Carefree assemblies that use the same fabric attachment system and roller tube diameter.
The Blue Fade colorway graduates across the fabric width, giving a styled look that complements a wide range of RV exterior paint and graphics. The topside color is Blue Fade; the underside is white, which reflects heat and keeps your patio area cooler on sunny days. Other colors and sizes are available separately -- make sure you select the correct size for your application.
Replacing awning fabric is a two-person job on most RV awning assemblies. The general process involves removing the roller tube from the awning arms, unwinding the old fabric, attaching the new fabric to the roller tube using the existing hem pocket or spline system, and rewinding before reinstalling. Lippert's Solera assembly uses a fabric hem pocket that slides over a spline on the roller tube -- no glue or staples required on most configurations.