When your patio awning fabric fades, tears, or cracks, you don't need a whole new awning system -- just the fabric. The Lippert V000334365 is a heavy-duty 13.5-oz vinyl replacement fabric built to fit 13 ft Solera, Dometic, and Carefree awning assemblies. Cold-crack tested to -25F and finished with heat-welded seams, this fabric is engineered to handle seasons of outdoor exposure, UV exposure, wind, and rain. The White Fade colorway delivers a clean, classic look that complements virtually any RV exterior.
This fabric is a direct replacement designed to work with the Solera roller awning system and is also compatible with Dometic and Carefree awning assemblies of the same size. The fabric width of 12'1" is intentionally sized approximately 11 inches shorter than the 13 ft awning assembly width -- this is by design, not a mistake. The standard fit accounts for end caps and mounting hardware on both sides.
Projection measures 8 feet from the wall of the RV to the drop edge, giving you solid shade coverage over a standard patio setup. The underside of the fabric is white, which helps reflect heat and brightens the space underneath -- a practical detail for summer camping.
Heavy commercial-grade vinyl resists UV degradation, mildew, and tearing better than lighter-weight fabrics common on budget replacements.
Fabric remains flexible and crack-resistant in extreme cold -- important for four-season RVers and those storing rigs in northern climates.
Seams are thermally bonded, not just stitched, creating a leak-resistant joint that holds up at the highest-stress points of the fabric panel.
A poly cord for an optional light track is sewn into the fabric. LED lights and the light track itself are sold separately.
Awning fabric is sized by the awning assembly length, not the fabric width. This V000334365 fabric fits a 13 ft awning assembly and has a finished fabric width of 12'1" -- approximately 11 inches shorter than the full assembly. This is the correct and expected fitment. If your awning assembly is 12 ft or 14 ft, you need a different size fabric.
To confirm your awning size, measure the full rail-to-rail width of the existing roller assembly or check the label on your awning hardware. Do not measure the old fabric itself, as worn or stretched fabric may not reflect the original spec.
This fabric is manufactured to work with the following awning platforms:
If you have an older awning brand or a less common system, verify that your roller tube diameter and end cap configuration match the Solera standard before ordering.
Replacing awning fabric is a two-person job. The general process involves removing the old fabric from the roller tube and rafter rail, feeding the new fabric into the bead channels or onto the roller, and securing the ends. Specific steps vary by awning model -- refer to your existing awning hardware for the exact retention method (bead, bolt rope, or clamp style).